ORION DO Probe for Lab or Field Instructions
- June 5, 2024
- Orion
Table of Contents
ORION DO Probe for Lab or Field
To use probe independently:
- Press and hold the power button on the probe for 3 seconds to activate; a flashing LED light will indicate the probe is activated.
- Press the power button again toy go into mode1
- Press the power button repeatedly until the desired vibration reached. 7fucnction for your choice .
- To turn off and deactivate probe, press and hold the power button for3 seconds. The LED will turn off.
- To use with remote:
- Press and hold the power button on the probe for 3 seconds to activate; Toy will go into mode1 directly based on toy’ turn on .
- Press function button of remote repeatedly until the desired function is reached. 7function for you choice .
- To turn off vibration ,press and hold the button on the remote for 3 seconds.
- To deactivate, press and hold button on the probe for 3 seconds.
- LED light will flash while charging and glow solid when fully charged. Fully charge product before use. Battery life depends on frequency and speed of use. We recommend fully charging your product once every 6 months.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliancecould void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>