GUANGDONG RF01 Remote Control User Manual
- June 5, 2024
- Guangdong
Table of Contents
GUANGDONG RF01 Remote Control
Remoter control instucitons
Control Method:
Adopt RF remoter to control the LED controller,which has 21 buttons,the
function of each button as the table below:
ON
|
Jump
|
OFF
|
---|---|---|---
Fade
8 COLOUR
| Flash white
8 COLOUR
| Chase
8 COLOUR
STEADY
ONE COLOUR
| FADE
ONE COLOUR
| FLASH
ONE COLOUR
FLASH OUT
ONE COLOUR
| CHASE
ONE COLOUR
| WAVE
ONE COLOUR
Static red| Static Green| Static blude
Static yellow| Static purple| Static cyan
Static white| Random colour| Auto change
- “ON” OFF” control power on or power off.
- Buttons in pink cyan, “JUMP” FADE” FLASH WHITE” CHASE” can auto-change different colours for different effect。
- Buttons in pink area，“STEADY”“FADE”“FLASH WHITE”“FLASH OUT”“CHASE” WAVE” are function keys，the other keys are colour keys。Please select the function key first, then color key.
- “AUTO” can auto-change different effects。
FCC ID: 2AVBD-RF01
FCCCaution
This devicecomplieswithpart15ofthe FCCRules.Operations are subject to the
following two conditions:(1)Thisdevicemaynotcauseharmfulinterference, and(2)
this device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device,pursuanttopart15oftheFCCRules.These limits are
designed to provide reasonable protection against harmfulinterferenceina
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and use in accordance with the
instructions, may cause harmful interference to radio communications. However,
the resin guarantee that interference will not occur in a particular
installation.If this equipment does cause harmful interference to radio Tele
vision reception, which can be determined by turning the equipment off and
on,the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TVtechnicianforhelp.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>