FALCON RIDGE PO-09RANGER-WD03 Folding Lexan Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE PO-09RANGER-WD03 Folding Lexan Windshield
Installation Instructions
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film. Once the film is removed you cannot return the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the 09” Polaris Ranger Lexan Windshield.
-
Check over the parts included in the cartons with the parts list shown below:
- 1 ¾” Loom Clamps 8 each
- 1” Stainless Steels Bolts 12 each
- 1 ¼” Stainless Steels Bolts 4 each
- Stainless Steel Washers 34 each
- Stainless Steel Lock Nuts 8 each
- Plastic Thumb Nuts 6 each
- Stainless Steel Nuts 4 each
- Rubber Gasket 1 each
- Bent Lexan Braces 2 each
- Lexan Windshield 1 each
If any parts are damaged or missing please contact customer service at 606-845-7439.
-
Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Next take the rubber gasket and starting at one end firmly place along entire bottom edge of the Windshield. You will need to peel back the protective film from the edge to install the gasket. If you leave the bulk of the protective film on while installing you can keep from scratching the windshield.
-
Next take the two bent Lexan braces and install them on the windshield. You will notice that one of the braces is shorter; this is the top brace and will go on the outside of the windshield at the top of the windshield. The bend will be above the bolts when installed. The bottom brace will go just below the hinge on the inside of the windshield. As before the bend will be above the bolts, when installed the brace should look like a shelf pointing towards the rear of the vehicle.
-
Now you are ready to place the windshield on the Ranger and attach to the roll cage. NOTE: THE BEND AT THE TOP OF THE WINDSHIELD SHOULD GO BELOW THE TOP TUBE. The diagram on the next page shows the proper placement for the hardware. Install the clamps as shown for the top two slots in the windshield only. Use the 1” bolts for this application.
-
Now install the clamp for the slot right above the hinge. You will use the 1 ¼” bolts for this. Below is the diagram showing how this is installed. You will have some of the bolt sticking out towards the front of the vehicle. This is to hold the bottom section of the windshield when it is in the raised position. You will use the same thumb nut for the raised and lowered positions.
-
Finally install a clamp around the tube blow the hinge as shown below. You will use the 1 ¼” bolts here. This clamp holds the bottom of the windshield down.
-
Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using microfiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Thank you for your purchase!
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from date item is received. You MUST package the product exactly as it
was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes. Lay all the windows on top of each other with the canvas
folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory-new condition to receive refund – a
25% restocking fee will apply. If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors’, you must first call them and
see what their return policy is. Once your item reaches our production
facility, our customer satisfaction team will inspect your item to ensure
unused, factory-new condition. NOTE: All windshields must be returned with the
original protective film intact and not removed. Do NOT REMOVE if you have any
intentions of returning the item. Refund/ replacement of a windshield will
only be processed on items with original protective film or if the windshield
is defective. Items must be properly packaged in the original shipping carton
to protect them during transit and ensure your returned item arrives back
factory fresh, and in new resalable condition (any returned items that have
been used, altered or damaged in any way will not be subject for a refund.)
All contents including instruction manuals, accessories, hardware, Velcro,
etc. must be included in your return shipment. Only items in OEM factory new
condition will be approved. Once returned items are received, credit will be
issued to the original credit card/ payment method used for the purchase.
Outbound shipping and return shipping cost will not be refunded. Please allow
4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty. 30 Day Warranty which includes and is not limited to
replacing the enclosure, tops and/or windshield due to defect of the product.
Please refer to the return policy in this case for more information. 1 Year
Warranty includes any defect in material or workmanship within this time frame
we will gladly correct the problem or replace the enclosure, tops &/or
windshield. Upon submitting for the correction or replacement we will need to
receive pictures of the defect in material or workmanship along with the
receipt from the date of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>