Imou IPC-FX2 Consumer Camera User Manual
- June 5, 2024
- imou
Table of Contents
Imou IPC-FX2 Consumer Camera
Packing List
Camera Introduction
About the Guide
- This quick start guide is for reference only. Minor difference might be found in user interface.
- All the design and software here are subject to change without prior written notice.
- All trademarks and registered trademarks mentioned are the properties of their respective owners.
- Please visit our website or contact your local service engineer for more information.
- If there is any uncertainty or controversy, please refer to our final explanation.
Operating with Imou Life App
-
Step 1
Scan the following QR code or search “lmou Life” in Google Play or App Store to download and install the app.
Note: If you have installed the app, update it to the latest version. -
Step 2
Run lmou Life App, and then register an account for the first use. -
Step 3
Connect the camera to power source with the power adapter. -
Step4
Wait for booting to be finished, and then the camera indicator flashes with green light. -
Step 5
Do the following operations to finish adding camera.
Note: If you have more than one camera, do step 5 to add them one by one.
If the Wi-Fi network has changed or the indicator status goes wrong, reset the camera, and then do step 5 to add it again.
Installing Camera
Note: Make sure that the mounting surface is strong enough to hold at least
three times of the device weight.
- Step1 Drill screw holes on the mounting surface as the positioning map shows, and then put in the expansion bolts.
- Step2 Attach the pedestal to the mounting surface with the self-tapping screws.
- Step3 Power up the camera, and then adjust the lens to the ideal angle.
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Federal Communication Commission Interference Statement :
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
RF Exposure: A distance of 20cm shall be maintained between the antenna and
users, and the transmitter module may not be co-located with any other
transmitter or antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>