cellgate WXL-P Series Multi-Tenant Installation Guide
- June 5, 2024
- Cellgate
Table of Contents
cellgate WXL-P Series Multi-Tenant
Recommended wiring: 18/6 shielded for main device, and 18/4 shielded for optional wiegand devicesItems Included in Kit.
- Watchman XL Unit
- 12 Volt DC Power Supply
- Magnetic Read Switch
- Keys (Note: Leave one key with the customer)
- Nuts
- Bolts X 4
- Quick Install Guide
- Activation & Test Process
- Customer Information Packet
Watchman XL Unit Power Supply Wiring
Interface Circuit Board
6-Wire Installation Instructions
- Wire main power from the transformer to the power connector on the circuit board.
- Connect gate trigger wires from the Normally Open (NO) and Common (C) to the free-exit or exit terminals on the gate operator.
- Connect the gate status wires on the 6-pin connector on the main relay and input plug to the magnetic switch or a Dry Contact, Normally Closed (NC)relay on the gate operator.
- If using an optional 26-bit reader (ex., keypad, card reader, RFID, or clicker), wire the device to the Wiegand connection on the interface circuit board.
- Use Camera Guide if adding optional external camera.
- Test/activate using the test credentials on the Activation & Test Process document.
Installation Testing
Enter the Testing Code, then tap the Enter Button
The Code will activate Relay 1 (the gate should open).Locate a Callgroup and tap on it to call it.
An automated message will play confirming the call was successful.
External Camera Installation
- If you’re installing an External Camera, call CellGate Support for testing.
- CellGate Support: 972-231-1999 option 3.
Customer Information
Leave the following items with the Customer:
- Customer Information Packet
- WXL – Key
Installation Complete
- Customer will setup Account with information in the Customer Packet
FCC STATEMENT
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: This device may not cause harmful interference, and
this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energBY and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.This equipment should be installed and operatedwith
minimum distance 20cm between the radiator& your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>