cellgate WATCHMAN W480 Cellular LTE Installation Guide
- June 16, 2024
- Cellgate
Table of Contents
WATCHMAN W480 Cellular LTE
Installation Guide
WATCHMAN W480 Cellular LTE
W480
Quick Install Guide
AA1MLPE ATT, AA1MLPE VZN,
AA1MLPE INT, AA1MLPE VPN
Items Included in Kit
The following items are included in your W480 delivery.
-
Watchman 480 Unit
-
12 Volt DC Power Supply
-
Magnetic Read Switch
-
Keys
NOTE Leave one key with the customer. -
Nuts X 4
-
Bolts X 4
-
Install Guide
-
Customer Information Packet
Wiring Examples
Recommended wiring: 18/6 shielded for main device, and 18/4
shielded for optional Wiegand devices.
Interface Circuit Board
The circuit board is oriented the same as the Watchman install.
If you requested an expansion board, we installed it.
We recommend the following gauges (ga) for each distance:
- 18 ga stranded: up to 25 ft
- 16 ga stranded: up to 50 ft
- 12 ga stranded: up to 60 ft
Internet Router Connection
Product Numbers: AA1MLPE ATT, AA1MLPE VZN, AA1MLPE INT, AA1MLPE
VPN
VPN Connection
Wiring with Transformer
Wiring for Solar Power
Interface Wiring Diagram
Oriented the same as the Watchman install
6-Wire Installation Instructions
- Wire main power from the transformer to the power connector on the circuit board.
- Connect gate trigger wires from the Normally Open (NO) and Common (C) to the free-exit or exit terminals on the gate operator.
- Connect the gate status wires on the 6 pin connector on the main relay and input plug to the magnetic switch or a Dry Contact, Normally Closed (NC) relay on the gate operator.
- If using an optional 26-bit reader (e.g., keypad, card reader, RFID, clicker), wire the device to the Wiegand connection on the interface circuit board.
- Use Camera Guide if adding external camera.
- Test and activate using the test credentials on the Activation & Test Process document.
Dry Contact Relay, Normally Open Dry Contact
No Voltage to Lock or Gate
Dry Contact Relay, Normally Closed Dry Contact
No Voltage to Lock or Gate
Lock Requiring Constant 12 V: Wet Contact Relay, Normally Open
Door/lock opens (releases) when power is added.
Lock Requiring Constant 12 V: Wet Contact Relay, Normally Closed
Door/lock opens (releases) when power is removed.
Wiegand Wiring to Board and Direct to Faceplate, 26 Bit Reader
To Interface Board
Magnetic Switch Setup
The Mag Switch can be placed anywhere that allows A and B to be pulled at
least 2 inches away from each other when the gate is open and within 1.5
inches when the gate is closed.
NOTE Gate statuses can be inverted. If needed, call Cell Gate to invert.
Magnetic Switch Wiring
Mounting to Standard Pedestal Mount
Mounting to Standard Pedestal Mount, Continued
