cellgate Watchman W450 Series Advanced Telephone Entry User Guide
- June 16, 2024
- Cellgate
Table of Contents
**cellgate Watchman W450 Series Advanced Telephone Entry User Guide
**
Items Included in Kit
- Watchman EVO Unit
- 12 Volt DC Power Supply
- Magnetic Read Switch
- Keys
- Nuts X 4
- Bolts X 4
- Quick Install Guide
- Activation & Test Process
- Customer Information Packet
Watchman EVO Unit
**Power Supply Wiring
**
Recommended wiring:
18/6 shielded for main device, and 18/4 shielded for optional Wiegand devices
Interface Circuit Board (Oriented the same as the Watchman install)
The circuit board is oriented the same as the Watchman install.
We recommend the following gauges (ga) for each distanc
- 18 ga stranded: up to 25 ft
- 16 ga stranded: up to 50 ft
- 12 ga stranded: up to 60 ft
Interface Wiring Diagram (Oriented the same as the Watchman install)
The supplied diode must be used for all magnetic lock installations, or the
warranty is voided.
Wire Installation Instructions
- Wire main power from transformer to the power connector on circuit board.
- Connect gate trigger wires from the Normally Open (NO) and Common (C) to the free-exit or exit terminals on the gate operator.
- Connect the gate status wires on the 6 pin connector on the main relay and input plug to the magnetic switch or a Dry Contact, Normally Closed (NC) relay on the gate operator.
- If using an optional 26-bit reader (keypad, card reader, RFID, or clicker), wire the device to the Wiegand connection on the interface circuit board.
- Use Camera Guide if adding optional external camera.
- Activate using test credentials on the Activation & Test Process document
Dry Contact Relay, Normally Open Dry Contact
No Voltage to Lock or Gate
Dry Contact Relay, Normally Closed Dry Contact
No Voltage to Lock or Gate
Lock Requiring Constant 12 V: Wet Contact Relay, Normally Open
Door/lock opens (releases) when power is added
Lock Requiring Constant 12 V: Wet Contact Relay, Normally Closed
Door/lock opens (releases) when power is removed
Wiegand Wiring to Board and Direct to Faceplate, 26 Bit Reader
To Interface Board
Magnetic Switch Wiring
Mounting to Standard Pedestal Mount
Mounting to Standard Pedestal Mount (continued)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>