Nedis HTBA10GY Bathroom Heater User Manual
- June 5, 2024
- nedis
Table of Contents
HTBA10GY Bathroom Heater
User Manual
Preface
Thank you for purchasing the Nedis HTBA10GY.
This document is the user manual and contains all the information for correct, efficient and safe use of the product.
This user manual is addressed to the end user. Read this information carefully before installing or using the product.
Always store this information with the product for use in the future.
Product description
Intended use
This product is a heater that allows the user to control the surrounding temperature in the bathroom.
This product is intended for indoor use only.
This product is only suitable for well insulated spaces or occasional use.
This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the product provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the product or perform user maintenance.
Children shall not play with the product.
The product is intended for use in household environments for typical housekeeping functions that may also be used by non-expert users for typical housekeeping functions, such as: shops, offices other similar working environments, farm houses, by clients in hotels, motels and other residential type environments and/or in bed and breakfast type environments.
This product is not suitable for primary heating purposes.
Any modification of the product may have consequences for safety, warranty and proper functioning.
Specifications
Product
|
Bathroom Heater
---|---
Article number
|
HTBA10GY
Dimensions (d x w x h)
|
100 x 560 x 160 mm
Input power
|
220-240 V ~ 50 Hz
Rating power
|
600 – 1200 W
Waterproof
|
IPX4
Cable length
|
1.3 m
Main parts (image A)
A
1. Bathroom heater
2. Wall mount
3. Mounting hole
4. Wall mount lid
5. Power cable
6. Screws (2x)
7. Plugs (2x)
8. Mode indicator
9. Pull cord
Safety instructions
WARNING
- Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep the packaging and this document for future reference.
- Only use the product as described in this document.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
- Do not drop the product and avoid bumping.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
- Do not use this heater in the immediate surroundings of a bath, a shower or swimming pool.
- Do not locate the product immediately below a power outlet.
- Unplug the product from the power source and other equipment if problems occur.
- Always use the voltage (A.C. Only) marked on the rating label.
- Before cleaning and maintenance, switch off the product and disconnect the product from the power source.
- Close supervision is necessary when the product is used by or near children, animals or infirm persons.
- Do not use the product near explosive or flammable materials.
- Always unwind the power cable before using the product.
- Do not let the power cable touch hot surfaces.
- Only use the product in the upright position.
- Keep the air inlet grill clean.
- The power cable cannot be replaced. If the cable is damaged the product should be scrapped.
- Disconnect the product from the power source before service and when replacing parts.
Explanation of the safety symbols on the product
Icon
|
Description
---|---
|
To avoid overheating, do not cover the product.
|
Indication for a hot surface. Contact may cause burns. Do not touch.
Explanation of the symbols on the product or packaging
Icon
|
Description
---|---
|
Electronic equipment needs to bear the CE mark in order to be marketed in the EU. CE marking shows that a product is assessed before being placed on the market and that it meets EU safety, health and environmental protection requirements. CE marking is also sometimes accepted as a means of compliance with type-approval requirements; for example, electronic components that require type-approval and also CE marking for electromagnetic compatibility (EMC) or low-voltage equipment.
|
This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.
|
Product in which protection against electric shock does not rely on basic insulation only, but which includes an additional safety precaution in such a way that means are provided for the connection of conductive parts (which are not live parts) to the protective (earthing) conductor in the fixed wiring in such a way that these parts cannot become live in the event of a failure of the basic insulation.
Installation
- Check the contents of the package
- Check that all parts are present and that no damage is visible on the parts. If parts are missing or damaged, contact the Nedis B.V. service desk via the website: www.nedis.com.
- Specify the precautions that must be taken when the local space heater is assembled, installed or maintained.
Bathroom zones (image B)
B
Never use the product while taking a shower or bath. This might cause an electric shock.
|
Bathroom
|
Shower room
|
Suitability
---|---|---|---
0
|
The area inside the bath.
|
The area inside the shower basin.
|
Not suitable
1
|
The area is the same width as zone 0 (the width of the bath) extending to 2.25 m above the finished floor level.
|
The area is 2.25 m from the finished floor level or the height of the fixed shower head.
|
Not suitable
2
|
The area is the same height as zone 1 (2.25 m), extended to 0.6 m around the bath.
|
The area is the same height as zone 1, extended to 0.6 m around the shower basin.
|
Not suitable
3
|
Remaining space
|
Remaining space
|
Suitable
Installing the product (image C + D)
C
D
- Only install the product in zone 3, at least 1.8 m above the ground and 30 cm below the ceiling.
1. Drill holes with a diameter of 8 mm and place the plugs A7.
2. Remove the wall mount lid A4 from the wall mount A2.
- The bathroom heater A1 can now rotate further than 40°.
3. Rotate A1 for better access to the mounting holes A3.
4. Fasten A1 with the screws A6.
5. Make sure the product hangs secure.
6. Place back A4.
- A1 is now limited to a rotation of 40°.
Use
Switching on the product
1. Plug the power cable A5 into a power outlet.
2. Pull the pull cord A9 repeatedly to switch between modes.
- The mode indicator A8 shows the current mode.
Mode
0
|
Off
1
|
600 W
2
|
1200 W
Maintenance
- Before cleaning and maintenance, switch off the product and disconnect the power. Let the product cool down.
- Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that can damage the surface.
- Do not use aggressive chemical cleaning agents such as ammonia, acid or acetone when cleaning the product.
Warranty
Any changes and/or modifications to the product will void the warranty. We accept no liability for damage caused by improper use of the product.
This product is designed for private use (normal domestic use) only. Nedis is not responsible for wear, defect and/or damages caused by commercial use of the product.
Disclaimer
Designs and specifications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks of their respective owners and are hereby recognized as such.
Disposal
|
This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>