FALCON RIDGE JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate Windshield Instruction Manual

June 3, 2024
FALCON RIDGE

JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate Windshield
Instruction Manual

JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate Windshield

NOTICE: Please check the contents of the package for any damage and make sure all parts fit correctly and you are happy with the product before removing the protective film. Once the film is removed you cannot return the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the John Deere XUV 550 / 550-S4 Aero-Vent Polycarbonate Windshield.

  1. Start by pulling parts out of the box and find a clean area to lay it down and install the hardware. Check over the parts included in the cartons with the parts list shown below:
    1 ¾” Loom Clamps| 6 each
    ---|---
    1” Stainless sheets of steel Bolts| 11 each
    Stainless Steel Washers| 15 each
    Plastic Thumb Nuts| 7 each
    Lock Nuts| 4 each
    Slide Fasteners| 4 each
    48” Rubber Gasket| 1 each
    Polycarbonate Brace| 1 each
    Polycarbonate Vent Slider| 1 each
    Polycarbonate Windshield| 1 each

If any parts are damaged or missing please contact customer service at 606-845-7439.

  1. Begin by peeling off the protective film; don’t peel all the film off so you can protect the windshield from getting scratched. Next, take the 50” piece of rubber gasket and starting at one end firmly place it across the bottom of the windshield. You may need to trim off the excess gasket. The diagram below shows where to install the gasket.
    FALCON RIDGE JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate
Windshield - Figure 1

  2. Next, install the sliding vent panel on the inside of the windshield as shown in the diagram below. To install slide fasteners, push through holes with your thumbs until it is completely through the hole in the windshield and locked in place.
    FALCON RIDGE JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate
Windshield - Figure 2

  3. Now the Windshield is ready to be installed. With the help of a friend, place the Windshield on the Gator, setting it up onto the hood.

  4. Take the remaining hardware and install the windshield to the roll cage as shown in the diagram below.
    FALCON RIDGE JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate
Windshield - Figure 3

  5. Now you can install the top brace if you want. If you do not have a Falcon Ridge Cab enclosure to work with this windshield, the top brace is not needed but can be installed for extra strength. Below is a diagram showing how the brace is to be installed.FALCON RIDGE JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate Windshield - Figure 4

  6. If you are using this windshield with a Falcon Ridge Cab enclosure, then you will use the Top Brace to sandwich the cab material and seal off the inside from the wind. The diagram below shows how it will work. If you aren’t using one of Falcon Ridge Cab Enclosures you may opt not to use the Top Brace or install it for added strength.
    FALCON RIDGE JD-550-WD05 John Deere XUV 550 550-S4 Aero-Vent Polycarbonate
Windshield - Figure 5

  7. Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using  microfiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.

Thank you for your purchase!

Return Policy

If for any reason you choose to return this product it must be returned within 30 days from the date the item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund – a 25% restocking fee will apply.
If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is  defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20%  restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition. NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE it if you have any intentions of returning the item. Refund/ replacement of a windshield will only be processed on items with original protective film or if the windshield is defective.
Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable  condition (any returned items that have been used, altered, or damaged in any way will not be subject to a refund.) All contents including instruction manuals, accessories,  hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, a credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping costs will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.

Warranty

To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure, tops, and/or windshield due to defects of the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

FALCON RIDGE User Manuals

Related Manuals