FALCON RIDGE YA-RHINO-FC04-2 Yamaha Rhino Full Cab Enclosure Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
YA-RHINO-FC04-2 Yamaha Rhino Full Cab Enclosure
Instruction Manual
Instructions for Installation and Care of Yamaha Rhino Full Cab Enclosure
with Lexan Windshield
Fits Factory Half Doors
YA-RHINO-FC04-2
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. The cab is Flammable.
- Be sure to read these instructions thoroughly before opening and installing the Yamaha Rhino Cab Enclosure. The installation is best done when the temperature is 70 degrees F. or warmer. If installed outside and in the cold weather, warming the adhesive Velcro strips inside just before installation is recommended.
- Carefully open the carton and remove the rolled Cab Enclosure on a large flat surface that is clean and free of dirt or other material that may soil or scratch the windows of the Cab.
- Check over the parts included in the carton with the parts list shown below:
Velcro Hook strips:| 2 each| 10” long
---|---|---
“ “| 2 each| 8” long
“ “| 1 each| 51” long
“ “| 14 each| 3” long
Cab Enclosure| 1 each| - Begin by opening up the enclosure and with the help of another person drape the enclosure over the roll cage. Mark where the two Velcro strips will pull down in the rear and attach the adhesive Velcro strips here. Now Pull the front of the doors down and make sure the top is being pulled tight and mark where the double-sided Velcro is that is sewn at the bottom of the front. Wrap the roll cage with the supplied 6” adhesive Velcro strips where the double-sided straps are going to be. Then pull the front of the door down and wrap the roll cage and Velcro with the double-sided Velcro, overlapping itself as it wraps around the roll cage.
- Now take the rest of the 6” adhesive strips and place them on the roll cage to match up with the tabs sewn down the front of the doors.
- Now attach the adhesive Velcro around the bottom of the doors. There is a 10” along the back of the doors and the adhesive Velcro to match up with these should be attached to the outside of the roll cage or straight out towards the sides.
- Next, take out the Lexan Windshield and read the instructions on how to install it. With the cab in place take the windshield and slide it up under the top of the cab and down onto the hood of the Rhino. You will need to slide the clamps under the front panels of the doors and around the roll cage to attach the windshield. After that, the only thing left is to place the 51” adhesive Velcro strip across the top of the windshield to match up with the Velcro sewn there.
- To open and stow the doors, move the zipper fully rearward and fold the bottom portion of the doors up. Then begin to form a vertical roll with the door by rolling it inward from the front edge toward the rear of the door. Secure in place using the two hook and loop straps provided. Try to form a roll approximately 2” in diameter to assure that the door will not stick out very far while stowed.
Cleaning and Storage Recommendations
- Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll it for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at normal room temperature. It is best not to expose the Cab to either extremely hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if the additional hook and loop sets are needed, they can also be ordered.
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from the date the item is received. You MUST package the product
exactly as it was originally packaged from the factory to get a full refund
for the product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes.
Lay all the windows on top of each other with the canvas folded in between and
the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory-new condition to receive a refund – a
25% restocking fee will apply.
If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors, you must first call them and see
what their return policy is. Once your item reaches our production facility,
our customer satisfaction team will inspect your item to ensure unused,
factory-new condition. NOTE: All windshields must be returned with the
original protective film intact and not removed. Do NOT REMOVE if you have any
intentions of returning the item. Refund/ replacement of a windshield will
only be processed on items with original protective film or if the windshield
is defective.
Items must be properly packaged in the original shipping carton to protect
them during transit and ensure your returned item arrives back factory fresh,
and in new resalable condition (any returned items that have been used,
altered, or damaged in any way will not be subject for a refund.) All contents
including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will
be approved.
Once returned items are received, a credit will be issued to the original
credit card/ payment method used for the purchase. Outbound shipping and
return shipping costs will not be refunded.
Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge’s Cab Enclosures, Tops &/or
Windshields!
Below are the terms under which your product is covered under our
manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure,
tops, and/or windshield due to defects of the product. Please refer to the
return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this
time frame we will gladly correct the problem or replace the enclosure, tops
&/or windshield. Upon submitting for the correction or replacement we will
need to receive pictures of the defect in material or workmanship along with
the receipt from the date of purchase.
Thank you,
Falcon Ridge
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>