FALCON RIDGE PO-14RZR-HT01 2014-17 Polaris RZR S and XP Hard Top Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of 2014-17 Polaris RZR S and XP Hard
Top
PO-14RZR-HT01
PO-14RZR-HT01 2014-17 Polaris RZR S and XP Hard Top
-
Be sure to read these instructions thoroughly before opening and installing the RZR Hard Top.
-
Check over the parts included in the carton with the parts list shown below:
1″ Bolts
1 1/4″ Bolts
1 5/8″ Loom Clamps
Large Stainless Washers
Large Rubber Washers
Small Washers
Lock Nuts
U-Nuts
24″ Adhesive Foam Padding| 2 each
4 each
2 each
6 each
6 each
2 each
2 each
4 each
1 each
---|--- -
Prior to installing the top, you must first remove the two front bolts that attach the front plastic piece to the frame. There are two bolts on each side but only remove the top bolt as shown in the photo below.
-
Remove the bolt and the U-Nut underneath the plastic. It helps to use a flathead screwdriver to pry it off.
-
Next, take to 4 U-Nuts provided and clip them onto the frame where you removed the old one in the front and one in the rear. Make sure to install the U-Nut on the outside hole in the rear.
-
Then take the 24″ adhesive foam padding strip and install them on the top of the roll cage across the rear bar.
-
Once all this is done take the 4 Bolts and run them through first the large stainless washer and then the large rubber washer. Now working your way around the top screw the bolts through the holes in the top and into the U-Nuts underneath. It helps to wait until all the bolts are loosely installed before tightening them down.
-
Finally, Take the two loom clamps and install them in the holes in the middle of each side. The diagram below shows how this is done.
-
This concludes your installation. Enjoy!!
Return Policy
If for any reason you choose to return this product it must be returned within
30 days from the date the item is received. You MUST package the product
exactly as it was originally packaged from the factory to get a full refund
for the product!
The vinyl windows should never be folded when packaging in the box or for
storage purposes. Lay all the windows on top of each other with the canvas
folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production
facility and must be in unused, factory-new condition to receive a refund – a
25% restocking fee will apply.
If ordered from Falcon Ridge please call at
606-845-7439 to gain a return
authorization number, use our preferred shipping carrier (UPS) to return the
item (unless the item is defective, you are responsible for paying the
shipping to return the item.) Any returns submitted to Falcon Ridge without a
return authorization number will be charged a 20% restocking fee. If ordered
from one of Falcon Ridge’s many distributors, you must first call them and see
what their return policy is. Once your item reaches our production facility,
our customer satisfaction team will inspect your item to ensure unused,
factory-new condition. NOTE: All windshields must be returned with the
original protective film intact and not removed. Do NOT REMOVE if you have any
intentions of returning the item. Refund/ replacement of a windshield will
only be processed on items with original protective film or if the windshield
is defective. Items must be properly packaged in the original shipping carton
to protect them during transit and ensure your returned item arrives back
factory fresh, and in new resalable condition (any returned items that have
been used, altered or damaged in any way will not be subject to a refund.) All
contents including instruction manuals, accessories, hardware, Velcro, etc.
must be included in your return shipment. Only items in OEM factory new
condition will be approved. Once returned items are received, a credit will be
issued to the original credit card/ payment method used for the purchase.
Outbound shipping and return shipping costs will not be refunded. Please allow
4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge’s Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure,
tops, and/or windshield due to defects of the product. Please refer to the
return policy in this case for more information.
- Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.
Thank you,
Falcon Ridge
Documents / Resources
|
FALCON RIDGE PO-14RZR-HT01 2014-17 Polaris RZR S and XP Hard
Top
[pdf] Instruction Manual
PO-14RZR-HT01, 2014-17 Polaris RZR S and XP Hard Top, PO-14RZR-HT01 2014-17
Polaris RZR S and XP Hard Top, Polaris RZR S and XP Hard Top, RZR S and XP
Hard Top, XP Hard Top, Hard Top
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>