Nedis IREX050BK IR Remote Control Extender User Manual
- June 5, 2024
- nedis
Table of Contents
IREX050BK IR Remote Control Extender
User Manual
Preface
Thank you for purchasing the Nedis IREX050BK.
This document is the user manual and contains all the information for correct, efficient and safe use of the product.
This user manual is addressed to the end user. Read this information carefully before installing or using the product.
Always store this information with the product for use in the future.
Product description
Intended use
This product amplifies and extends the infrared signal from a remote control to a device connected with this product, even when your devices are concealed.
The product is intended for indoor use only.
The product is not intended for professional use.
Any modification of the product may have consequences for safety, warranty and proper functioning.
Specifications
Product
|
IR Remote Control Extender
---|---
Article number
|
IREX050BK
Dimensions (l x w x h)
|
78 x 43 x 19 mm
Operating range
|
7 m
Infrared frequency range
|
30 – 60 KHz
Extender probes
|
3 Y type LEDs (1, 1.5, 2 m)
Input power
|
5 VDC ; 100 mA
Power consumption
|
1 W
A
1. IR Remote Control Extender
2. Micro USB port
3. IR extender
4. Micro USB – USB cable
5. Screws (2x)
6. Infrared receiver port Rx
7. Infrared receiver port Tx
8. IR receiver
Safety instructions
WARNING
- Only use the product as described in this manual.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective device immediately.
- Do not drop the product and avoid bumping.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
- Disconnect the product from the electrical outlet and other equipment if problems occur.
- Do not expose the product to water or moisture.
- Do not open the product.
- If the power cable is damaged, it must be replaced by a special cable or assembly available from the manufacturer or its service agent.
- Only use provided parts.
Product labels
|
Electronic equipment needs to bear the CE mark in order to be marketed in the EU. CE marking shows that a product is assessed before being placed on the market and that it meets EU safety, health and environmental protection requirements. CE marking is also sometimes accepted as a means of compliance with type-approval requirements; for example, electronic components that require type-approval and also CE marking for electromagnetic compatibility (EMC) or low-voltage equipment.
---|---
|
Indication that the producer of the packaging material complies with the Packaging Law and has contributed to the costs of the ‘Green Dot’ waste separation and recycling system.
|
Indication to explain that the product needs to be collected separately when disposed. Do not throw in the trash bin.
Installation
- Check the contents of the package
- Check that all parts are present and that no damage is visible on the parts. If parts are missing or damaged, contact the Nedis B.V. service desk via the website: www.nedis.com.
Installing the product
- Make sure all the devices you want to connect have been switched off.
1. Plug the IR extender A 3 into the infrared receiver port Tx A 7.
2. Secure the cable of the IR receiver A 8 using the hooks.
3. Plug the cable of A 8 into the infrared receiver port Rx A 6.
4. Place A 8 near the remote.
5. Place the IR Remote Control Extender A 1 and A 3 near your device.
6. Plug the Micro USB – USB cable A 4 into the USB port A 2.
7. Plug A 4 into a power source.
Maintenance
- Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that can damage the surface.
- Do not use aggressive chemical cleaning agents such as ammonia, acid or acetone when cleaning the product.
Warranty
Any changes and/or modifications to the product will void the warranty. We accept no liability for damage caused by improper use of the product.
Disclaimer
Designs and specifications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks of their respective owners and are hereby recognized as such.
Disposal
|
This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.
---|---
Declaration of Conformity
We, Nedis B.V. declare as manufacturer that the product IREX050BK from our brand Nedis®, produced in China, has been tested according to all relevant CE standards and regulations and that all tests have been passed successfully. This includes, but is not limited to the RED 2014/53/EU regulation.
The complete Declaration of Conformity (and the safety datasheet if applicable) can be found and downloaded via webshop.nedis.com/IREX050BK#support
For additional information regarding the compliance, contact the customer service:
Web: www.nedis.com
E-mail: service@nedis.com
Phone: +31 (0)73-5991055 (during office hours)
Nedis B.V., de Tweeling 28
5215 MC ’s-Hertogenbosch, the Netherlands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>