FALCON RIDGE PO-150-TC01 Polaris Ranger 150 Soft Top Instruction Manual

June 3, 2024
FALCON RIDGE

FALCON RIDGE PO-150-TC01 Polaris Ranger 150 Soft Top

FALCON-RIDGE-PO-150-TC01-Polaris-Ranger-150-Soft-Top-
PRO

INSTALLATION INSTRUCTION

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
Be sure to read these instructions thoroughly before opening and installing the top cap. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to installation.

  1. Carefully open the carton and remove the rolled up Cab Enclosure on a large flat surface that is clean and free of dirt or other material that may soil or scratch the windows of the Cab.

  2. Check over the parts included in the carton with the parts list shown below:

    • 2” Adhesive Velcro Hook 2 each 6” Long
    • Webbing Straps w/ Loop 2 each 30″ Long
    • Webbing Straps w/ Velcro 2 each
      If any parts are damaged or missing please contact customer service at 606-845-7439.
  3. Included in the package are two webbing straps with a loop sewn on one end. These will be used to secure the rear of the Top Cap. Wrap it around the bar just under the side safety bars as shown in the photos below.FALCON-RIDGE-PO-150-TC01-Polaris-Ranger-150-Soft-Top-1

  4. Now run the looped end of one of the strap around the roll cage just under the top of the safety bar on the side. Then pull the other end of the strap through the loop and pull tight. Photo below shows how it should look.FALCON-RIDGE-PO-150-TC01-Polaris-Ranger-150-Soft-Top-2

  5. Now pull the strap up and run them through the buckles sewn into the rear corners of the Top Cap as shown in the photos on the next page.

  6. Moving to the front of the vehicle you will use the straps with double-sided Velcro sewn to one end. Where you attach the Velcro is up to you and can depend on whether you have a windshield installed or not. First wrap the roll cage with the 5” adhesive Velcro strip and then wrap the double-sided Velcro around that tightly so that the strap is pointed upward towards the top cap.

  7. Now run the end of the strap through the buckle as you did in the rear. Pull all straps tight making sure the top is centered and pulled evenly on all four corners.

  8. Now your enclosure should be complete. With proper care your cab should last for years to come. Enjoy!!!

Return Policy

If for any reason you choose to return this product it must be returned within 30 days from date item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production facility and must be in unused, factory new condition to receive refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition. NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/ replacement of a windshield will only be processed on items with original protective film or if the windshield is defective.
Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered or damaged in any way will not be subject for a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.

Warranty

To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defects of the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

FALCON RIDGE User Manuals

Related Manuals