Nedis BACH07 Universal Charger User Manual
- June 5, 2024
- nedis
Table of Contents
BACH07 Universal Charger
User Manual
Preface
Thank you for purchasing the Nedis BACH07.
This document is the user manual and contains all the information for correct, efficient and safe use of the product.
This user manual is addressed to the end user. Read this information carefully before installing or using the product.
Always store this information with the product for use in the future.
Product description
Intended use
The BACH07 is a charger for type AA, AAA, 9V NiMH rechargeable batteries.
The charger is only intended to charge NiMH type batteries. Do not try to charge any other type of batteries like Alkaline or Lithium.
This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children shall not play with the product. Cleaning and user maintenance shall not be done by children without supervision.
The product is intended for indoor use only.
The product is not intended for professional use.
Any modification of the product may have consequences for safety, warranty and proper functioning.
Specifications
Product
|
Universal Charger
---|---
Article number
|
BACH07
Dimensions (l x w x h)
|
69.6 x 66.4 x 109.6 mm
Input voltage
|
100 – 240 VAC ; 50 / 60 Hz
Input current
|
58 mA
Output
|
4 x 1.2 VDC 200 mA (AANiMH rechargeable batteries)
Max. 2650 mAh
|
4 x 1.2 VDC 50 mA (AAANiMH rechargeable batteries)
Max. 2650 mAh
|
4 x 9 VDC 13 mA (9VNiMH rechargeable batteries)
Max. 250 mAh
Discharge cut off voltage
|
0.8 VDC
Main parts (image A)
A
1. Universal Charger
2. Mode switch
3. Status indicator LED
Safety instructions
WARNING
- Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep this document for future reference.
- Only use the product as described in this document.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
- Do not drop the product and avoid bumping.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
- Disconnect the product from the power source and other equipment if problems occur.
- Do not expose the product to water or moisture.
- Non-rechargeable batteries are not to be recharged.
- Do not short-circuit a cell or a battery.
- Do not mix cells of different manufacture, capacity, size or type within a product.
- Battery usage by children should be supervised.
- Seek medical advice immediately if a cell or a battery has been swallowed.
- In the event of a cell leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.
- When not in use, disconnect the product from the power source.
- Only power the product with the voltage corresponding to the markings on the product.
- Disconnect the product from the power soure before placing or removing batteries.
- Provide enough ventilation during charging.
- Do not dismantle, open or shred batteries.
- Do not expose cells or batteries to heat or fire. Avoid storage in direct sunlight.
- Observe the plus (+) and minus (–) marks on the cell, battery and equipment and ensure correct use.
- After extended periods of storage, it may be necessary to charge and discharge the cells or batteries several times to obtain maximum performance.
Safety symbols on the product
Icon
|
Description
---|---
|
Electronic equipment needs to bear the CE mark in order to be marketed in the EU. CE marking shows that a product is assessed before being placed on the market and that it meets EU safety, health and environmental protection requirements. CE marking is also sometimes accepted as a means of compliance with type-approval requirements; for example, electronic components that require type-approval and also CE marking for electromagnetic compatibility (EMC) or low-voltage equipment.
|
Indication to warn for electric shock.
|
Product in which protection against electric shock does not rely on basic insulation only, but in which additional safety precautions such as double insulation or reinforced insulation are provided, there being no provision for protective earthing or reliance upon installation conditions NOTE A Class II products may be provided with means for maintaining the continuity of protective circuits, provided that such means are within the product and are insulated from accessible surfaces according to the requirements of Class II.
|
Indication to explain the product is suitable for indoor use only.
|
Indication to explain that the product should be recycled appropriately.
|
Indication to explain that the product needs to be collected separately when disposed. Do not throw in the trash bin.
Installation
- Check the contents of the package
- Check that all parts are present and that no damage is visible on the parts. If parts are missing or damaged, contact the Nedis B.V. service desk via the website: www.nedis.com.
Installing the product
Insert or change AA batteries (image B)
B
Insert or change AAA batteries (image C)
C
Insert or change 9V batteries (image D)
D
Use
1. Place the batteries (not nicluded) as shown in images B, C and D
- Make sure to match the (+) and (-) polarity markings.
- It is recommended to only charge batteries of the same type and capacity at a time.
2. Switch the mode switch A 2 to the preferred setting.
3. Plug the product into a power outlet.
- The status indicator LED A 3 lights up red.
- When the inserted batteries are fully charged or discharged A 3 switches off.
- Discharging stops when the battery reaches the limit of 0.8V.
4. Disconnect the product from the power outlet.
5. Remove the batteries.
Maintenance
- Unplug the product before cleaning.
- Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that can damage the surface.
- Do not use aggressive chemical cleaning agents such as ammonia, acid or acetone when cleaning the product.
- Do not clean the inside of the product.
Warranty
Any changes and/or modifications to the product will void the warranty. We accept no liability for damage caused by improper use of the product.
Disclaimer
Designs and specifications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks of their respective owners and are hereby recognized as such.
Disposal
|
This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>