Kruger Matz KM0559 Wireless Speaker Owner’s Manual

Kruger Matz KM0559 Wireless Speaker

SAFETY INSTRUCTION

1. Place the device on flat, stable surface.
2. Do not place heavy objects on the device.
3. Do not place anything in speakers interior.
4. Do not place the device in close proximity to heat sources, such as radiators etc. Do not place the device on unstable surfaces.
5. Position the device in a properly ventilated place. Do not obstruct ventilation by covering ventilation openings.
6. Protect this device from humidity, water and other liquid. Avoid using/storing it in extreme temperatures. Do not expose it to direct sunlight and other sources of heat.
7. Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
8. Keep the volume at a reasonable level throughout entire time of using the speaker. To prevent damage to your hearing, do not raise the volume too high.
9. If you experience tinnitus, discomfort or other concerning behaviors, stop using the device immediately.
10. Make sure, that the device is placed away from electrical devices that generate
11. Disconnect from power outlet if the device is not going to be used for a long time.
12. Do not handle this device with wet hands.
13. Do not use this device if it has been damaged.
14. Do not attempt to repair this device yourself. In case of damage, contact authorized service point for check-up or repair.
15. Always disconnect the product from the power source before cleaning.
16. lean this device with a soft, slightly damp cloth. Do not use any chemical agents to clean this device.

FRONT PANEL

1. Microphone input
2. AUX input
3. Micro SD slot
4. Charging indicator
5. USB port
6. Power switch
7. Previous track button / volume down button
8. Play / pause / TWS function button
9. Next track button / volume up button
10. Mode / light button
11. Micro USB charging port

REMOTE CONTROLLER

1. Power button
2. Mode / light button
3. Previous track button
4. Volume down
5. Volume up
6. Choose song number correctly / Set FM frequency in Radio mode
7. Play / pause / TWS function button
8. Equalizer
9. Mute
10. Stop button
11. Repeat track
12. Next track button

OPERATION

Turning on / off / volume adjustment

To turn on the speaker, slide the power switch to the ON position. To turn off the speaker, slide the power switch to the OFF position. The volume is adjusted by pressing and holding the track change / volume control buttons. To turn on or off the light, press and hold the mode button.

Playing via Bluetooth

If there is no external device connected (USB or AUX), the speaker will automatically go to Bluetooth mode, after turning it on. If there is an external device connected, press the mode button, to go to Bluetooth mode. On the external device, search for Bluetooth devices and connect to the speaker (KM GO!). Played music can be controlled on the external device, with the buttons on the speaker or by the remote controller.

Playing via USB

After plugging the USB drive, the speaker will automatically go to USB mode. To control played music, use buttons on the speaker or use remote controller.

Playing via AUX

After plugging the cable to the AUX input, the speaker will automatically go to AUX mode. To control played music, use external device.

FM Radio

To play the radio, press the mode button, until there is a voice command “Radio”. Press the play button to run automatic scan. Saved stations can be switched with the next and previous track buttons. To manually set the FM frequency, use the numeric keypad on the remote control, e.g. to select the frequency 98.3, dial 983.

Microphone

After connecting the microphone to the microphone input, it can be used immediately. Note: microphone cord has to be mono.

TWS function

TWS function allows for playing from one source on two speakers. After turning on the speakers, press and hold the PLAY button on one of them for 3 seconds. Connection will be signaled with an audio cue. After connecting the external device, the sound will be played on both speakers.

Charging

Low battery level will be signaled with icon on the display. Connect one plug of the USB cable to the micro USB port of the device, connect the other plug to the AC charger or a compatible PC USB port.

SPECIFICATION

• Power: 8 W
• Impedance: 2,8 Ohm
• Frequency response: 50 Hz ~ 18 kHz
• S/N ratio: >80 dB
• Drive unit: 2 x 4”
• FM frequency: 87,5 – 108MHz
• Bluetooth: 5.0
• Supported formats: MP3
• TWS function (connect two speakers)
• I/O:
  • USB port 2.0
  • 1 x microphone input (Jack 6,3 mm)
  • AUX input (Jack 3,5 mm)
  • Micro USB input
  • Micro SD slot
• Power supply: 5 V
• Battery: 3,7 V / 1800 mAh
• Dimensions: 307 x 142 x 145 mm
• Weight: 1,4 kg

Lechpol Electronics Sp. z o.o. Sp.k. hereby declares that Wireless speaker KM0559 is consistent with directive 2014/53/UE.
Full text of the EU Declaration of Conformity is available at the following Internet address: www.lechpol.eu.

LEARN MORE

For more information on this device visit: www.krugermatz.com. Read the owner’s manual carefully before using it.
Visit www.krugermatz.com website for more products and accessories.
In case of any doubts or questions reach out to our Frequently Asked Questions section.

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)

(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature indicates that it should not be disposed of with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of waste and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their suppliers and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.

Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>