FALCON RIDGE Oreion Reeper Black Diamond Plate Hard Top Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE Oreion Reeper Black Diamond Plate Hard Top
- Check over the parts included in the carton with the parts list shown below:
- 40” Side Bulb Gasket ———————————————- 1 each
- 1 ½” Loom Clamp ————————————————- 4 each
- 1” Bolts ————————————————————– 4 each
- Large Rubber Washers—————————————— — 4 each
- Large Stainless Washers—————————————- — 4 each
- Small Washers —————————————— ———– 4 each
- Locknuts ————————————————————- 4 each
- Adhesive Pads 2″ ————————————————- 8 each
- Hard Top
- Begin by installing the gasket across the front. See photo below for proper placement.
- Next place the top on the vehicle and line the front up with the top of the windshield. Look to see where the top is going to touch the bars running down the middle. Take the top back off and attach the adhesive pads to the bottom surface where it will hit the bars to alleviate any noise. Please see photos below.
- Now replace the top on the vehicle and proceed to clamp it to the roll cage. Use the four 1 ½” clamps to attach the top. The 1” Bolts will run down through the top and then through the clamp. The diagram below shows how to install clamps.
- After the Top is secured with the clamps the last step is to take the two straps in the front corner and snap them to the top snap down the side. Please see photo below.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>