FALCON RIDGE Kawasaki Mule 3010 Soft Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE Kawasaki Mule 3010 Soft Windshield
Instructions for Installation
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
-
Be sure to read these instructions thoroughly before unrolling and installing the cab enclosure. The installation is best done when the temperature is 65 degrees F. or warmer.
-
Carefully unroll the Windshield on a large flat surface that is clean and free of dirt or other material.
-
Check over the parts included in the carton with the parts list shown below:
Velcro Hook strips: 6 each 8” long- “ “ 1 each 17” long
- “ “ 1 each 25” long
- Windshield 1 each
-
Start installation by placing the 25 adhesive Velcro hook strip centered along the top of the roll cage. You will want to place it halfway between the top and inside of the bar, or diagonally toward the top inside. Now you can place the windshield over the front and hang it from this position so that you can locate the remaining Velcro positions.
-
Next note the correct position for the 17latch strip on the brush guard at the front of the Mule. Clean the area with Isopropyl alcohol, let dry and apply the Velcro hook strip. Then attach the Cab to the strip around the brush guard.
-
Position and install the six (3 per side) 8 hook and loop strips on the left and right sides of the roll cage on either side of the front window. Be certain to clean the surfaces before applying the adhesive hook strips! First, apply all three strips on one side of the roll cage then pull the window tightly toward the other side to minimize waviness or wrinkles in the front window.
-
Finally, wrap the small straps in the top corners of the windshield around the roll cage, overlapping the hook and loop the secure.
Cleaning and Storage Recommendations
- Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag (I recommend a Flannel or Micro Fiber Cloth) or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>