FALCON RIDGE Oreion Epic Black Diamond Plate Hard Top Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
Oregon Epic Black Diamond Plate Hard Top
Instruction Manual
2505 Bypass Rd, Flemingsburg, KY
41041606-845-7439
Instructions for Installation and Care of Oregon Epic 4×4
Diamond Plate Aluminum Roof MD-EPIC-HT01
Oregon Epic Black Diamond Plate Hard Top
1. Check over the parts included in the carton with the parts list shown
below:
40″ Side Bulb Gasket ———————- 1 each
1 ½” Loom Clamp ———————— 8 each
1″ Bolts ———————————- 14 each
Large Rubber Washers————– 14 each
Large Stainless Washers——————– 14 each
Small Washers ————————— 14 each
Locknuts ————————— 14 each
47.5″ Rubber Strip —————————– 1 each
2″ Rubber Strips ————————- 10 each
6″ Slide-in Velcro Tab —————————— 2 each
6″ adhesive Velcro Strips ———————- 2 each
2. Hard Top
a. Begin by installing the gasket across the front. See the photo below for
proper placement.
b. Now place the 47.5″ rubber strip on top of the front edge of the rear
section of the roof. The strip will cover all the holes along this edge. Make
sure it is well adhered to the roof and then take a razor or knife and cut the
holes out. Then place the front roof section on top of the rear section and
bolt them together using the round holes. The long holes will be used to
attach the roof to the roll cage.
c. Next place the top on the vehicle and line the front up with the top of the
windshield. Look to see where the top is going to touch the bars running down
the middle. Take the top back off and attach the 2″ rubber strips to the
bottom surface where it will hit the bars to alleviate any noise. Please see
the photos below.
d. Now replace the top on the vehicle and proceed to clamp it to the roll
cage. Use the four 1 ½” clamps to attach the top. The 1″ Bolts will run down
through the top and then through the clamp. The diagram below shows how to
install clamps.
e. After the Top is secured with the clamps the last step is to take the two
6″ Velcro Tabs and slide them into the two channels along the front edge of
the roof. Use the two 6″ adhesive Velcro strips and place them along the
bottom of the window frame as shown in the photos below. Then pull the tabs
down tight and attach them to the adhesive strips to hold the front edge down.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>