brandmotion 9002-2904 Dual Camera Blind Spot Monitoring Instruction Manual
- June 5, 2024
- BRANDMOTION
Table of Contents
brandmotion 9002-2904 Dual Camera Blind Spot Monitoring Instruction Manual
Items Included in the Kit
- 2 Adjustable angle camera pods
- 2 Chassis harness
- 2 Double sided tape/gaskets Mounting screws
- 4 Screw hole caps
- 2 Angle adjustment tools
- 4-way video switcher
Tools & Supplies Needed
- Wire strippers
- Wire cutters
- Electrical tape
- Zip ties
- Plastic panel removal tools
- Digital Volt Meter / BCM safe test light
- Screwdriver
- Socket set
- Wrench
Safety Precautions
- Work in well ventilated area that is clear of obstructions.
- Secure vehicle with tire chucks in both front and rear of tires.
- Turn vehicle accessories OFF and ensure ignition key is in OFF position.
- Wear safety goggles and snug fitting clothes.
- Use tools only for their intended purpose and which are in good repair.
- Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color instructions, as well as an installation video, please visit www.brandmotion.com
INSTALLATION INSTRUCTIONS
- Remove the inner door panel to gain access to the wiring and side view mirror mounting bolts.
- Carefully remove the mirror glass from the mirror. Each vehicle is different; consult the vehicles service guide for how to proceed.
- Clean the bottom of the mirror then attach the 3m double-sided tape to the bottom of the mirror where the camera should be mounted.
- Remove the mirror from the vehicle and housing from the vehicle.
- Drill 2 pilot holes for the mounting screws and drill a hole in the center of the double-sided tape for the harness to be ran through.
- Run the camera harness into the mirror and through the arm of the mirror, into the door.
- Attach the camera to the mirror with the double-sided tape.
- Screw in the 2 mounting screws into the holes in the camera.
- Snap in the two-screw hole mounting covers.
- Run the camera harness into the vehicle through the door boot.
- Connect the camera to the harness with the power and RCA connection.
- Repeat for the other the door.
- Connect the Yellow video RCA from the camera to the correct RCA input. Left or right depending on the door that is being worked on
- Connect the trigger wires from the video switcher to the positive turn signal wires. Left input trigger wire is white, the right input trigger wire is green.
- Connect the video output male RCA from the video switcher to the input of the interface or video display.
- Check the angle and view, if the angle needs to be changed use supplied tool to adjust the angle of the camera.
- Reassemble the vehicle in the reverse order.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>