SERVER 100745 Extreme Countertop Dispenser Owner’s Manual
- June 5, 2024
- SERVER
Table of Contents
SERVER 100745 Extreme Countertop Dispenser
Tips and tricks to help you get started with your new Extreme™ Dispenser
-
Remove unit from box and wash all parts properly before use.
-
Squeeze the pinch valve open to ensure it isn’t stuck shut, then insert into the pump housing.
-
Press dome into housing fully and wrap the loop around the lower opening to secure.
-
Install tube by lubricating with a small amount of water and rotate and position until both pegs on housing fit into holes on tube.
-
Lubricate connector with a small amount of water and rotate and position until both pegs on connector fit into holes on tube.
-
Insert discharge fitting into pump housing discharge tube. Place loop of fitting around the peg on the end of discharge tube to secure.
-
Place condiment pouch on flat surface with pouch fitment facing upward. Remove pouch cap.
-
Insert pump connector into pouch fitment and rotate locking collar clockwise to secure. Prime pump by pushing condiment toward connector and squeeze pump dome several times until product is visible in pump.
-
Place pouch in the rear compartment of the unit. Slide pouch connector grooves into the unit divider channel. Insert pump into slots inside front of unit
-
Fold two back corners of the pouch over the side walls and close the lid. This helps with evacuation.
-
If you didn’t prime in step 8, press the lever several times until you see the product in the discharge tube.
WANT TO LEARN MORE?
Visit server-products.com/manual-more for your manual, part breakdown, support videos and more. spsales @server-products.com | 800.558.8722