FALCON RIDGE PO-RZR-TRS-HT01 Polaris RZR Trail S Hard Top Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE PO-RZR-TRS-HT01 Polaris RZR Trail S Hard Top Instruction
Manual
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
-
Be sure to read these instructions thoroughly before opening and installing the Ranger RZR Hard Top.
-
Check over the parts included in the carton with the parts list shown below:
1 1/4″ Bolts 4 each
Large Stainless Washers 4 each
Large Rubber Washers 4 each
Small SS Washers 4 each
Locknuts 4 each
42″ Adhesive Foam Padding 2 each -
First take the 42″ adhesive foam padding strip and install them on the top of the roll cage down both sides of the roll cage facing up wards towards the sky.
-
Once that is done take the 4 bolts and run them through first the large stainless washer and then the large rubber washer. Now working your way around the top place the bolts with washers through the holes and into the corner braces of the roll cage. On the inside use the small washers and lock nuts to finish attaching the roof. It helps to wait until all the bolts are loosely installed before tightening them down.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>