FALCON RIDGE PO-RZR-TRS-RW01 Polaris RZR Trail S Soft Rear Window Instruction Manual

FALCON RIDGE PO-RZR-TRS-RW01 Polaris RZR Trail S Soft Rear Window Instruction Manual

Inductions

CAUTION: Do not smoke inside the cab or expose the enclosure to direct flames. Product is FLAMMABLE.
Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best done when ambient temperature is 70°F or warmer. If installed in cold weather, warming the adhesive Velcro strips before installation is recommended.

1. Carefully open the carton and remove the rolled up Cab Enclosure on a large flat surface that is clean and free of dirt or other material that may soil or scratch the windows of the Cab.
2. Check over the parts included in the carton with the parts list shown below:
   Doors:
   Velcro Hook strips:
   “ “ 1 each 26” long
   “ “ 2 each 18” long
   Snap studs: 5 each (1 extra)
   Rear Window: 1 each

REAR WINDOW

1. a. Take the 26” adhesive hook strip and attach it to the rear top bar of the roll cage making sure that it faces up towards the sky. See photo below
   

2. b. The sides of the rear window will attach to the roll cage using the two 18” adhesive hook strips as shown in the photo below.
   
   

3. c. Lastly attach the snaps along the bottom of the rear window as shown in the photo below.
   

Cleaning and Storage Recommendations

1. Before removing the Falcon Ridge for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
2. It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.

2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>