HYUNDAI IND 233 Double Induction Hot Plate Instruction Manual

HYUNDAI IND 233 Double Induction Hot Plate

Dear customer, thank you for purchasing our product. Please read the operating instructions carefully before putting the appliance into operation and keep these instructions including the warranty, the receipt and, if possible, the box with the internal packing.

GENERAL SAFETY INSTRUCTIONS

• Check whether the data on the type label correspond with the voltage in your socket. The power cord plug has to be connected to the properly connected and grounded socket according.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• Before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
• Do not leave the appliance plugged in power supply without supervision!
• If the power cord of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.
• Never use the appliance if its power cord or plug is damaged, if it does not work properly, if it fell down and was damaged and it is leaking. In this case take the appliance to a special service to check its safety and proper function.
• The product is intended for home use and similar (in shops, offices and similar workplaces, in hotels, motels and other residential environments, in facilities providing accommodation with breakfast). It is not intended for commercial use!
• Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately. Do not put it in water.
• To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance.
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Pay careful attention to the following “Special Safety Instructions for this unit“.

SPECIAL SAFETY INSTRUCTIONS FOR THIS UNIT

• Do not connect the plug to a socket where several other appliances are already plugged in.
• This appliance is for indoor use only.
•  If the surface is cracked, switch off the appliance to avoid the possibility of electric shock.
•  Do not use the unit if the cord is damaged or if the plug does not securely fit the socket.
• Do not use this unit near an open flame or humid places.
•  Keep the unit out of children’s reach.
• Place the unit on a stable, flat surface.
• Do not carry the hob when the pot or the pan is situated on it.
• Do not heat or overheat a pot when it is empty.
• Do not place metal objects such as knives, forks, spoons, lids, cans and aluminium foils on the top surface or under the bottom of the stove..
• Make sure there is sufficient space (keep a minimum distance of 5 to 10 cm to walls or other items) surrounding the cooking area.
• Never use the unit on low-heat-resistant materials (carpet, vinyl).
• Do not place paper between the pot or the pan and the unit. The paper may burn.
• Do not block the air supply or exhaust vent.
• Caution! The surface will remain hot for a period of time after use, due to radiant heat.
• Unit can affect the items having or attracting magnetic fields, such as radios, televisions, automatic banking cards and cassette tapes
• Do not use the unit on the metallic surface.
• Do not disconnect the power cord immediately after cooking, at least 15 seconds is necessary to cool down the unit.
  WARNING: HOT SURFACE

GENERAL DESCRIPTION

• P1 Induction top surface – 1300 W
• P2 Induction top surface – 1600 W
• P3 Main ON/OFF switch
• P4 MENU button – setting mode
• P5 Dial – setting value
• P6 POWER control light „P“
• P7 TEMP control light „°C“
• P8 TIMER control light “

THE FUNCTION MODE AND PRODUCT ADVANTAGES OF INDUCTION HOTPLATES

• With induction hotplates, an electric voltage is applied on a conductor spool beneath the glass ceramics. This creates magnetic fields, which directly heat up the bottom of the cookware through a physical effect.
• This means saving time and energy, because contrary to common hotplates, the cookware is heated up, not the heating element and the glass ceramics. Due to the technical characteristics described above, another advantage is the very short start-up cooking time.
• In addition, the heat supply promptly adapts to changed settings and can be controlled in small steps.¨The induction hotplate reacts to changed settings just as fast as a gas stove, as the energy reaches the pot immediately without having to heat up other materials first.
• The induction technology combines this fast reaction with the basic advantage of electricity, meaning being able to exactly adjust the heat supply.
• Additional advantages of an induction hotplate:
  • As the hotplate is only heated up indirectly via the bottom of the cookware, over spilling food cannot stick and burn and there is hardly any danger of burns for the user. The glass ceramics is only heated up by the hot cookware.
  • Once you take the cookware off the hotplate, the device automatically switches to standby mode.
  • The device detects whether suitable cookware is placed on the hotplate. If this is not the case, no energy is transmitted.

SUITABLE AND UNSUITABLE COOKWARE

Suitable Cookware

• pots and pans with magnetic bottom, as stainless steel pots with iron bottom, cast iron, enamelled pans

• Flat-bottom pans and pots with a diameter of 13 to 18 cm with magnetic bottom

• Max. weight pot and content 6 kg
  Unsuitable Cookware

• Pots/pans with a diameter of less than 13 cm

• Ceramic pots, heat-proof glass

• Copper pots and pans, aluminium pots and ans

•  Cookware with feet

• Containers with a curved bottom

INSTRUCTIONS FOR USE

• Insert the plug into a suitable socket.
• You will hear an acoustic signal. Now the device enters standby mode.
• Place suitable cookware in the centre of the hotplate.
• Now press the ON/ OFF switch to turn on the induction cooker. The LED will show „ON“ and you will hear an acoustic signal.
• Press „MENU“ button to select HEAT mode power setting. The display 1300 W (plate )  or 1600 watts (plate ). Turn the dial for setting desired power.
• Press again the „MENU“ to switch to mode TEMP, which is activated with a maximum of 240 ° C. Turn the dial to select the desired temperature.
• Press again the „MENU“ button to switch to mode HEAT with maximum power with a timer, the display shows „0:00“. Turn the dial to select the desired cooking time in minutes. After selecting the cooking time will start counting down the remaining time. The default power is 1300 W (plate ) or 1600 watts (plate ). After the start of the countdown, you change the power by turning dial.
• Press again the „MENU“ button to switch to mode TEMP with cooking timer, the display shows „0:00“. Turn the dial to select the desired cooking time in minutes. After selecting the cooking time will start counting down the remaining time. The default temperature is set at 240 ° C. After the start of the countdown, you can change the temperature by turning the dial.

HEAT

• In this mode, the user can adjust the power output of the unit. You change the power by turning dial.

• Power settings:

  • Plate
    200 – 350 – 500 – 650 – 800 – 900 – 1000 – 1100 – 1200 – 1300 W

  • Plate
    200 – 350 – 500 – 650 – 800 – 1000 – 1100 – 1200 – 1400 – 1600 W

TEMP – HEATING ACCORDING TO THE SET TEMPERATURE
The temperature sensor, located underneath the glass-ceramic plate, monitors the bottom temperature of the cookware. The user selects required temperature and the thermostat compares the selected temperature with the temperature of the bottom of the coockware. When the selected temperature is reached, the power will be disconnected. When the actual temperature of the bottom of the coockware is lower then the selected temperature, the power will come ON again. This mode keeps the selected temperature in a thermal range (+-20°C). This mode is in fact somewhat more comfortable and economic.The pre-set temperature stage „240 °C“ is selected and the device turns on (Temperature stages: 60, 80, 100, 120, 140, 160, 180, 200, 220 and 240°C). You can change the settings at any time, by turning dial.

TIMER FUNCTION:
The control “ appears next to the display. 5 sec after setting the value the TIMER cooking will
start and time will be countdowned in one minute intervals. Control lights “ and „P“ will lights for all timer interval. Once the time is up, you will hear an acoustic signal and the device automatically enters standby mode.

FUNCTION

AUTOMATIC TURN OFF WHEN LIFTING AWAY THE DISH
When the cooking dish is lifted away from the cooking surface, the unit will TURN itself OFF. If the dish is returned back on the surface within 40 sec, the cooking process will resume with the pre-lifting settings. If the dish is NOT returned back within 40 sec, the unit will TURN OFF completelly.
WARNING: Once the cooking or warming process is finished, disconnect the mains plug from the out-let!

MAINTENANCE AND CLEAN

• Clean the appliance after each use. Disconnect the plug and wait until the unit cooled off. Do not use fuel, paint thinner, a brush or polishing powder to clean the induction cooker.
• Wipe the unit using a dish washing agent and a damp cloth. Use a vacuum cleaner to remove dirt from the air supply and exhaust vent.
• Wipe off the ceramic field with a damp cloth or use a mild, non-abrasive soap solution.
• Wipe off the casing and the operating panel with a soft cloth or a mild detergent.
• Prevent water from running over the unit (if water gets inside the unit, the cooker may malfunction).

Error Code List:
If LED-display shows the error code, please reference to the solution as following.

competent after-sales service
E2| Temperature sensor damaged| Contact the manufacturer or a competent after- sales service
E3| Voltage too high| Have your power supply checked; Unplug the appliance, wait about 2 min. and plug in the appliance again
E4| Voltage too low| Have your power supply checked; Unplug the appliance, wait about 2 min. and plug in the appliance again
E5| Temperature on the ceramic plate too high; pot/pan empty; pot/pan has too high temperature| Wait a few minutes and let the plate or pot/ pan cool down
---|---|---
E6| Cooling or exhaust fan damaged| Contact the manufacturer or a competent after-sales service;

Clean the louvers on the housing and restart the appliance

TECHNICAL SPECIFICATIONS

• Double Induction hot plate

• Saving of time and power – warming up during few seconds due to induction technology

• Ceramics hotplate is cold to the touch – ease of maintenance and high safety

• Automatic shutdown with remove dishes

• Easy control by turning dial

• LED display and control-light

• Black crystal glass, dimension 290 x 470 mm

• 10-level temperature setting: 200 – 1300 W (front plate), 200 – 1600 W (back plate)

• Temperature range: 60-240°C, steps 20°C

• Timer: up to 180 minutes use

• For cookers with average 13 – 18 cm

• Color black

• Power supply: 230 V ~ 50 Hz

• Noise level < 50 dB (A)

• Power drain: 2900 W, size: 31 x 7 x 60 cm, weight: 4,2 kg
  We reserve the right to change technical specifications.

• Input in standby mode is ˂ 1,00 W.

• Input in off mode is ˂ 0,50 W.
  WARNING: Do not use this product near water, in wet areas to avoid fire or injury of electric current. Always turn off the product when you don’t use it or before a revision. There aren’t any parts in this appliance which are reparable by consumer. Always appeal to a qualified authorized service. The product is under a dangerous tention.

Old electrical appliances, used batteries and accumulators disposal

This symbol appearing on the product, on the product accessories or on the product packing means that the product must not be disposed as household waste. When the product/ battery durability is over, please, deliver the product or battery (if it is enclosed) to the respective collection point, where the electrical appliances or batteries will be recycled. The places, where the used electrical appliances are collected, exist in the European Union and in other European countries as well. By proper disposal of the product you can prevent possible negative impact on environment and human health, which might otherwise occur as a consequence of improper manipulation with the product or battery/ accumulator. Recycling of materials contributes to protection of natural resources. Therefore, please, do not throw the old electrical appliances and batteries/ accumulators in the household waste. Information, where it is possible to leave the old electrical appliances for free, is provided at your local authority, at the store where you have bought the product. Information, where you can leave the batteries and accumulators for free, is provided to you at the store, at your local authority.

References

• Úvod - ECOBAT
• Úvod | ELEKTROWIN, a.s.
• Úvod - Envidom
• Hyundai Electronics– Hyundai CZ
• SEWA - OZV | elektroodpad | batérie | obaly

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>