Nedis WIFILR001BK Smart Remote Control User Manual
- June 5, 2024
- nedis
Table of Contents
WIFILR001BK Smart Remote Control
User Manual
Preface
Thank you for purchasing the Nedis WIFILR001BK.
This document is the user manual and contains all the information for correct, efficient and safe use of the product.
This user manual is addressed to the end user. Read this information carefully before installing or using the product.
Always store this information with the product for use in the future.
Product description
Intended use
The Nedis WIFILR001BK is a remote control to control multiple bulbs of the WIFILRXXX series.
The product is intended for indoor use only.
The product is not intended for professional use.
The product is intended for use in household environments for typical housekeeping functions that may also be used by non-expert users for typical housekeeping functions, such as: shops, offices other similar working environments, farm houses, by clients in hotels, motels and other residential type environments and/or in bed and breakfast type environments.
This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children shall not play with the product. Cleaning and user maintenance shall not be done by children without supervision.
Any modification of the product may have consequences for safety, warranty and proper functioning.
Specifications
Product
|
Smart Remote Control
---|---
Article number
|
WIFILR001BK
Dimensions (l x w x h)
|
130 x 28 x 14 mm
Power input
|
3 VDC ; < 0.2 A
Operating temperature
|
-20 °C – 40 °C
Operating humidity
|
Up to 60%
Frequency range
|
2412 – 2484 MHz
Maximum transmit power
|
16 dBm
Battery
|
2x AAA
Main parts (image A)
A
1. Indicator LED
2. On button
3. Decrease brightness
4. Off button
5. Increase brightness
6. Battery compartment
Safety instructions
WARNING
- Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep the packaging and this document for future reference.
- Only use the product as described in this document.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
- Do not drop the product and avoid bumping.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
- Do not expose the product to water or moisture.
- Disconnect the product from the power source before service and when replacing parts.
- For battery safety, consult the manual of the batteries.
- Do not mix cells of different manufacture, capacity, size or type within a product.
- Only use the battery type(s) recommended in this document.
- Keep cells and batteries clean and dry.
- When possible, remove the battery from the product when not in use.
- Use only the cell or battery in the application for which it was intended.
- Wipe the cell or battery terminals with a clean dry cloth if they become dirty.
- Battery usage by children should be supervised.
- Observe the plus (+) and minus (–) marks on the cell, battery and equipment and ensure correct use.
- Dispose of the cell or battery properly.
- Seek medical advice immediately if a cell or a battery has been swallowed.
Explanation of the symbols on the product or packaging
Icon
|
Description
---|---
|
Product in which protection against electric shock does not rely on basic insulation only, but in which additional safety precautions such as double insulation or reinforced insulation are provided, there being no provision for protective earthing or reliance upon installation conditions. NOTE A Class II products may be provided with means for maintaining the continuity of protective circuits, provided that such means are within the product and are insulated from accessible surfaces according to the requirements of Class II.
Installation
- Check the contents of the package
- Check that all parts are present and that no damage is visible on the parts. If parts are missing or damaged, contact the Nedis B.V. service desk via the website: www.nedis.com.
Placing the batteries
- Use only size AAA batteries (not included) for this product.
- Observe the plus (+) and minus (–) marks on the cell, battery and equipment and ensure correct use.
1. Open the battery compartment A6.
2. Place the batteries.
3. Close A6.
Use
Connecting the product
1. Switch the lamp off and on once to activate pairing mode.
- Perform the following step within 20 seconds.
2. Press and hold the on button A2 for 10 seconds until the indicator LED A1 starts blinking.
- The lamp blinks three times when the product has been connected successfully.
- Repeat the steps to connect the product to multiple lamps.
Disconnecting the product
1. Press and hold the off button A4 for 10 seconds to disconnect the lamps from the product.
Maintenance
- Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that can damage the surface.
- Do not use aggressive chemical cleaning agents such as ammonia, acid or acetone when cleaning the product.
- Disconnect the product from the power source before service and when replacing parts.
- Wipe the cell or battery terminals with a clean dry cloth if they become dirty.
Warranty
Any changes and/or modifications to the product will void the warranty. We accept no liability for damage caused by improper use of the product.
This product is designed for private use (normal domestic use) only. Nedis is not responsible for wear, defect and/or damages caused by commercial use of the product.
Disclaimer
Designs and specifications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks of their respective owners and are hereby recognized as such.
Disposal
|
This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.
---|---
Declaration of Conformity
We, Nedis B.V. declare as manufacturer that the product WIFILR001BK from our brand Nedis®, produced in China, has been tested according to all relevant CE standards and regulations and that all tests have been passed successfully. This includes, but is not limited to the RED 2014/53/EU regulation.
The complete Declaration of Conformity (and the safety datasheet if applicable) can be found and downloaded via:
WIFILR001BK #support”>nedis.com/ WIFILR001BK#support
For additional information regarding the compliance, contact the customer service:
Web: www.nedis.com
E-mail: service@nedis.com
Phone: +31 (0)73-5991055 (during office hours)
Nedis B.V., de Tweeling 28
5215 MC ’s-Hertogenbosch, the Netherlands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>