OPTONICA LED Built-In Module Square User Manual
- June 5, 2024
- OPTONICA
Table of Contents
Built-In Module Square
USER MANUAL
Mounting instructions
1
| 1.
Cut off the electricity.
---|---
2
| 2.
Cut the ceiling according to the product ceiling cutout diameter size.
3| 3. Connect the driver to the power cable Connectfixturetothedriver.
Make sure that the product is connected safely.
4
| 4.
Push the springs upward into the hole and release it.
5| 5. Fixtures are ready to use.
| | | |
---|---|---|---|---
3W| 6W| 12W| 18W| 24W
| | | |
---|---|---|---|---
3W
2431
2432
2433
2444
2445
2446| 6W
2434
2435
2436
2447
2448
2449 | 12W
2437
2438
2439
2450
2451
2452| 18W
2335
2440
2336
2348
2349
2453 | 24W
2441
2442
2443
2454
2455
2456
INSTALLATION INSTRUCTIONS
The installation of the luminaire must be performed by a qualified technician. Supply voltage of the light: 230V/50Hz
- Before you begin the installation, make sure the power is off.
- Connect the terminals of the input voltage of the power supply to the power cord from the mains.
- Insulate connections to prevent short circuits
Prima Group 2004 Ltd. is not responsible for damage caused by improper installation. This product complies with the following EU Directives:
– LVD 2014/35/EU
– EMC 2014/30/EU
IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1,
bI. 144, Ground Floor; Phone: +359 2 988 45 72;
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>