anslut FROST PROTECTION CABLE 230 V User Manual
- June 5, 2024
- anslut
Table of Contents
User Manual
417049+
FROST PROTECTION CABLE
OPERATING INSTRUCTIONS
Original instruction
Jula AB reserves the right to make changes to the product. Jula AB claims
copyright on this documentation. It is not allowed to modify or alter this
document in any way and the manual shall be printed and used as it is in
relation to the product. For the latest version of operating instructions,
refer to the Jula website.
SYMBOLS
| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
| Recycle discarded products in accordance with local regulations.
TECHNICAL DATA
| Operating voltage | 230 VAC |
|---|---|
| Basic model | 85 CM (SS 4242411) |
| Max operating temperature | 65°C |
| Lowest installation temperature | -30°C |
| Minimum bending radius | 35 mm |
| Output | 10 W/m at +10°C for routing on a metal tube |
| Size | 8.0 x 5.7 mm |
Maximum cable length:
External routing:| 100 metres – (max 10 A)
Internal routing:| 60 metres – (max 10 A)
DESCRIPTION
The product consists of a heating cable and a 2 m long connecting rubber cable with a plug. It is connected to a 230 V power point. The heating cable is designed to automatically limit the heat when necessary. There is no risk of overheating the heating cable. The product has an IP68 rating.
- Outer sheath
- Reinforcement, tinned copper
- Insulation TPE
- Self-limiting core material
- Wire, tinned copper
FIG. 1
APPLICATIONS
The product can be used for a wide range of applications:
- Antifreeze protection of pipes, external routing
- Antifreeze protection of pipes, internal routing
- Water meter
- Caravan
- Greenhouse
- Compost
ASSEMBLY
INSTALLATION
Pay attention to the following before installation
- The maximum connected length for internal routing is 60 m and for external routing 100 m.
- The maximum fuse is 10 A.
- The maximum permitted pressure for installation in water pipes is 8 bar.
- The heating cable is intended for temporary installations.
- The heating cable should always be connected via a residual current device.
- The heating cable should only be covered with material that can withstand at least + 65°.
- The rubber cable cannot be replaced – if damaged, discard the complete heating cable.
Installing external antifreeze protection
Fasten the cable with electrical tape to the pipe or part you want to protect
from freezing. Always insulate the pipe or part to retain the heat. If the
cable is too long, or to increase the effect, you can also wind the cable
around the pipe or part in a spiral. Wind the cable around water meters or
large pipe fittings. The cable can be crossed over itself, neither the cable
nor the part will overheat.
Installing internal antifreeze protection
- When the heating cable is connected it always produces some effect, and this always increases the temperature of the water. Internal routing produces much more of an effect than external routing. The operating temperature, and therefore the water temperature, varies depending on the routing, insulation thickness, and ambient temperature.
- For permanent use, and especially for longer lengths, the cable should be controlled via a thermostat.
- For installation in a water pipe, you need a suitable watertight grommet. The grommet is fitted on the heating cable. The junction should be outside the water pipe.
Installation in water pipe
- Fit a T-coupling on the water pipe.
- Fit the supplementary unit.
- Push in the heating cable and screw tight.
- The product consists of a self-limiting heating cable primarily intended for antifreeze protection of water and drain pipes.
2022-04-05
WWW.JULA.COM
© JULA AB
JULA AB
BOX 363, 532 24 SKARA, SWEDEN
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>