WISI OH892 COMPACT HEADEND Instructions

June 5, 2024
WISI

WISI OH892 COMPACT HEADEND Instructions

Dust cap for CI slot

  • Reception of two DVB-T/C signals and transmodulation into dual COFDM-TV channels (bonded)

  • Input frequency range 45–878 MHz

  • Output frequency range 45–870 MHz

  • Hinweis: Nach erfolgter Programmierung ziehen Sie das Handset ab.
    Note: After programming disconnect the handset.

Saving data

Data are saved automatically after leaving the parameter, or 60 seconds after the last entry

Front-LED / Front LED indication

rot/red
decoding input signal flashing decoding input signal, output data rate too high
green/yellow Some services must be removed!

Instructions

The following description is only an example, which is combined from services of different transponders. It displays the available services.
The services are represented with a consecutive number, followed by the service name. The symbol “” or “#” are showing the status of the Decryption: “” stands for FTA (free to air), and “#” stands for an encrypted service. The next symbol shows the type of service: “T” for TV, “R” for radio. One service can be selected by pushing the left-key, and a “” symbol appears at the right hand side on the display. By pushing the same key again, the selected service wil be added to the list for decryption, and the symbol “” will be replaced by the symbol “$”. By pushing the left button another time, the selected service will be removed from decryption.

Attention:

If the PID-filter operates in transparent mode (PID-Mode: transp), any service can‘t be removed from the list, it only can be selected between “*” and “$”.
If the output of one channel is switched off, or the module isn‘t within the multiplexing mode, no service selection can be done, and all services are displayed as disabled.

* Wird „inactive

  • If „inactive“ displayed, the filter is not active. It is possible to select a PID in the range from 0x0000 to 0x1fff. Is the selected value under 0x0000 the filter will be set to „inactive“.
    The inputs with leading 0x must be entered in hexadecimal format. Should no PID filter be used, set the menu PID-0 to „inactive“. Attention: If the settings for the input parameter „Sat-IF“ or „SymRate“ are changed, all filter settings will be deleted and set to „inactive“.

Read More About This Manual & Download PDF:

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals