WISI DRP 1533 Flex Switch Plug-in power supply Instruction Manual
- June 5, 2024
- WISI
Table of Contents
WISI DRP 1533 Flex Switch Plug-in power supply
SPECIFICATIONS
- For the use with the WISI FLEXSWITCH multi-switch series
- Operating voltage 230 V AC
- Output power 15 V DC
- Output current 3,3 A short circuit proof
Safety and warning notes
- Please read these user instructions before use the plug-in.
- This switch mode plug-in changes mains alternating current to touch-safe low voltage and may be used only under the technical data listed below.
- The switch mode plug-in is only designed for indoor use and should not come into contact with water or dust. To prevent overheating the power supply should not be covered when it is in use. Vibrations and special environmental factors on the device are inadmissible.
- The main socket should be easily accessible. In the event of operational error, the plug must be immediately removed from the socket.
- The power supply is started up when the plug is inserted in the socket. To turn off the power supply, the plug must be removed from the socket. Never pull at the cable.
- The power supply contains dangerous voltages and the cover should not be removed.
- All service or maintenance work should be carried out by qualified personnel who can get assistance by contacting the manufacturer’s agent. With visible damages to the device do not use this anymore.
- An internal fuse protects the power supply against short circuiting in the primary circuit.
- In the event that the fuse needs to be replaced, the same type with the same breaking characteristic and size of fuse should always be used.
- The power supply is double-insulated (insulation class II) and needs no earth connector.
- The power supply is provided with a DC cable and exclusively for powering of DRC and DRT- multi switches from the WISI Communications Company. One end of the DC cable is equipped with a connector of type 5.5/2.1 mm. By a good assembly at the multi-switch it prevents an unintended interruption of the DC power.
- This switch mode plug-in has a plastic casing and shouldn’t contact with oils, grease etc., as most types of plastic can be broken down by chemicals and solvents.
- The Plug-in power supply designated for the permanent operation in satellite reception systems. For the use with WISI FLEXSWITCH multi switches DRx xxxx
- PRESERVE THESE INSTRUCTIONS AT A SURE PLACE ON!
Technical data
|
---|---
General data|
Connector| Niedervoltstecker 5.5/2.1 mm / Connector type DC 5.5/2.1 mm
Input voltage| 100..240 V AC (50/60 Hz)
Operating range| 90…264 V AC (50/60 Hz)
Output voltage| 15 V DC
Max. load current| 3,3 A
Max. Power consumption| 49,5 W
Average operational efficiency| 87,8 %
Efficiency at low load (10%)| 80,6 %
Max. humidity, noncondensing| 75 %
Safety class system| II
Protection class system EN 60529 (DIN 40050)| IP40
Electrical safety standard| EN 60950-1
EMC| EN 50083-2
Dimensions without plug| 116 x 33 x 51 mm
Operating temperature| -20…+40 °C
Storage temperature| -10…+80 °C
Article number| 74983
WISI Communications GmbH & Co. KG Empfangs- und Verteiltechnik Wilhelm-Sihn- Strasse 5-7 75223 Niefern-Öschelbronn Germany HRA 700359 Inland: Phone +49 7233-66-0 Export: Phone +49 7233-66-0 Email: info@wisi.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>