ANSLUT 423917 Wall Lamp Instruction Manual
- June 5, 2024
- anslut
Table of Contents
ANSLUT 423917 Wall Lamp
SAFETY INSTRUCTIONS
Read the operating instructions carefully before use
Save them for future reference.
- Switch off the power supply before installation, dismantling or any other work.
- The earth wire must always be connected.
- Use wires with a cross-sectional area of at least 1 mm2
- Use a 2-pin power switch.
- The bulb gets hot when it is switched on. Do not touch the bulb until it has cooled.
- Disconnect the power supply and allow the bulb to cool before replacing.
- Never use bulbs with a higher output than specified on the type plate and in Technical data.
- Never use the product if the cover (top part) is damaged. Replace the cover as soon as possible.
- Do not look directly at the light source.
TECHNICAL DATA
- Rated voltage: 230 V ~ 50 Hz
- Protection rating: IP44
- Socket: E27
- Max output (light source): 60W
- Dimensions: 25.5 x 24 x 37 cm
INSTALLATION
WARNING: Carefully read the safety instructions and make sure the power supply is disconnected before installation. Follow the instructions below. Contact an electrician if you are unsure.
- Drill holes in the wall and insert plugs.
- Insert two self-threading screws through the plastic bracket as shown in the figure below.
- Screw on the plastic bracket.
- Strip off 6 mm of the insulation and leave 10 mm of insulated wire as shown in the diagram below.
- Connect the brown wire (1) to the terminal (L), the blue wire (2) to the terminal (N) and the green-yellow wire (3) to the earth terminal (ak).
- Put the coupler plug in the plastic bracket.
- Put the lamp on the bracket and screw tight with the two nuts with round heads.
- Fit a bulb in in the bulb holder (see section Rep/acing bulb). Check that the bulb does not exceed the maximum output specified on the type plate and in the section Technical data.
MAINTENANCE
Treat with acid-free oil, for example WD-40, 3-4 times a year. We do not recommend using stainless lamps in exposed and corrosive environments.
Replacing bulb
IMPORTANT: Disconnect the power supply before replacing the bulb.
- Remove the top cover.
- Allow the bulb to cool and carefully unscrew it (do not touch the bulb with bare hands).
- Carefully screw in the new bulb.
- Fit the top cover before reconnecting the power supply.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>