KUZCO PD90115 Ceiling LED Pendant Instruction Manual
- June 5, 2024
- KUZCO
Table of Contents
KUZCO PD90115 Ceiling LED Pendant
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ElLV (Electronic Low Voltage) or TRIAC type of dimmer is required
- 120V input
INSTRUCTIONS
- Remove fixture fromits original package
- Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package
- To change fixture height, push and hold wire gripper (2g), slide wire to desired length and then release wire gripper (2g) to secure
- Make proper electrical connections (black to hot “L” white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and place driver (4a) inside canopy (2a)
- Attach canopy (2a) tomounting plate (1c) with canopy screws (2b)
- Tilt shades (5a) to desired position
- Fine tone wire length if necessary, by push and hold wire gripper (2g) and then adjust wire to desired length
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>