KUZCO CH85224 Ceiling LED Chandelier Instruction Manual

KUZCO CH85224 Ceiling LED Chandelier

START FROM HERE

• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference

Please Note:

• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
• Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
• 120V input

FEATURE

1. Remove fixture from its original package
2. Separate mounting plate (1c) from the canopy (2a) by removing canopy screws (2f)
3. Attach mounting plate (1c) to electrical junction box (1a) using screws provided (1e) in the hardware package
4. Secure mounting plate (1c) to the mounting surface with anchors (1f) and screws (1h)
5. To change fixture height, push and hold the wire gripper (2g), slide the wire to the desired length and then release the wire gripper (2g) to secure
6. Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package
7. Attach canopy (2a) to mounting plate (1c) with canopy screws (2f)
8. Fine tone wire length if necessary, by push and hold wire gripper (2g) and then adjust the wire to the desired length

19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com

References

• Kuzco Lighting – Modern Contemporary Lighting.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>