MEAN WELL PLD-16 Series 16W Single Output LED Power Supply Owner’s Manual

June 3, 2024
MEAN WELL

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
product

Features

  • 115VAC or 230VAC models available
  • Built-in active PFC function
  • Constant current design
  • Protections: Short circuit/ Over temperature
  • Cooling by free air convection
  • Fully isolated plastic case
  • Class 2 Power Unit
  • Class II power unit, no FG
  • IP42 design Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)
  • 100% full load burn-in test Low cost High reliability 3 years warranty

Specification

MODEL| PLD-16-350| PLD-16-700| PLD-16-1050| PLD-16-1400
---|---|---|---|---
OUTPUT| RATED CURRENT| 350mA| 700mA| 1050mA| 1400mA
OPERATING VOLTAGE RANGE| 24 ~ 48V| 16 ~ 24V| 12 ~ 16V| 8 ~ 12V
CURRENT ACCURACY| ±5.0%
RATED POWER| 16.8W| 16.8W| 16.8W| 16.8W
RIPPLE & NOISE (max.) **Note.1| 4.6Vp-p| 2.7Vp-p| 2.2Vp-p| 2Vp-p
NO LOAD OUTPUT VOLTAGE (max.)| 60V| 35V| 25V| 16V
SETUP TIME| 500ms / 230VAC   2000ms / 115VAC at full load
INPUT| FREQUENCY RANGE| 47 ~ 63Hz
POWER FACTOR (Typ.)| PF>0.9/115VAC, PF>0.9/230VAC, PF>0.9/277VAC at full load (Please refer to “Power Factor Characteristic” curve)
TOTAL HARMONIC DISTORTION| A series| THD< 20% when output loading≧70% at 115VAC
B series| THD< 20% when output loading≧70% at 230VAC input and output loading≧80% at 277VAC input
EFFICIENCY (Typ.)| A series| 84.5%| 84.5%| 84%| 82.5%
B series| 85.5%| 86%| 85%| 83.5%
AC CURRENT (Typ.)| 0.4A/115VAC     0.2A/230VAC      0.15A/277VAC
INRUSH CURRENT(Typ.)| COLD START 20A(twidth=25μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A CIRCUIT**

BREAKER

| A series| 58 units (circuit breaker of type B) / 58 units (circuit breaker of type C) at 115VAC
B series| 128 units (circuit breaker of type B) / 128 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT| <0.5mA / 240VAC
PROTECTION| SHORT CIRCUIT| Hiccup mode, recovers automatically after fault condition is removed.
OVER TEMPERATURE| Shut down o/p voltage, re-power on to recover
ENVIRONMENT| WORKING TEMP.| -30 ~ +50℃ (Refer to “Derating Curve”)
WORKING HUMIDITY| 20 ~ 95% RH non-condensing
STORAGE TEMP., HUMIDITY| -40 ~ +80℃, 10 ~ 95% RH
TEMP. COEFFICIENT| ±0.03%/℃ (0 ~ 50℃)
VIBRATION| 10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes
SAFETY & EMC| SAFETY STANDARDS| UL8750,CSA C22.2 No.250.0-08;ENEC BS EN/EN 613471-1,BS EN/EN 61347-2-13 independent, BS EN/EN62384(for B type only), EAC TP TC 004, IP42 approved
WITHSTAND VOLTAGE| I/P-O/P:3.75KVAC
ISOLATION RESISTANCE| I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
EMC EMISSION| Compliance to BS EN/EN55015 (B type only), BS EN/EN61000-3-2 Class C ; BS EN/EN61000-3-3, FCC part 18 non-consumer equipment(A type only), EAC TP TC 020
EMC IMMUNITY| Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN61547, light industry level, EAC TP TC 020
OTHERS| MTBF| 6807.7K hrs min.     Telcordia SR-332 (Bellcore) ; 872.4Khrs min.      MIL-HDBK-217F (25℃)
DIMENSION| 845729.5mm (LWH)
PACKING| 0.19Kg; 72pcs/14.7Kg/0.92CUFT
Note|

  1. Ripple & noise are measured at 20MHz of bandwidth by using a 12 twisted pair-wire terminated with a 0.1uf & 47ut parallel capacitor.
  2. Direct connecting to LEDS IS Suggested, but is not suitable for using additional drivers.
  3. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently connected to the mains.
  4. The ambient temperature derating of 3.5 C/1000m with fanless models and of 5C/1000m with fan models for operating altitude higher than 2000m(6500ft)
  5. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf x Product Liable Disclaimer: For detailed information. please refer to httos://www.meanwell.com/serviceDisclaimer.aspx

Mechanical Specification

Type:(PLD-16-_A)

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
01

Type:(PLD-16-_B)

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
02

Block Diagram

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
03

Derating Curve

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
04

Static Characteristics

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
05

Power Factor Characteristic

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
06

EFFICIENCY vs LOAD (PLD-16-350)

MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
07

Documents / Resources

| MEAN WELL PLD-16 Series 16W Single Output LED Power Supply [pdf] Owner's Manual
PLD-16 Series, 16W Single Output LED Power Supply, PLD-16 Series 16W Single Output LED Power Supply, Output LED Power Supply, LED Power Supply, Power Supply
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

MEAN WELL User Manuals

Related Manuals