VISUAL COMFORT ARN 5480 Casoria Petite Single Pendant Instruction Manual
- June 5, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT ARN 5480 Casoria Petite Single Pendant
ASSEMBLY INSTRUCTIONS
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
- Phillips Screwdriver
- Slotted Screwdriver
- Wire Strippers
- Wire Cutters
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from canopy (F) by removing collar ring (G).
-
Install mounting plate (B) to junction box and secure with mounting screws (C).
-
Feed electrical and ground wires through collar ring (G) , canopy (F) and top rod (H).
-
Holding fixture upright, slide collar ring (G) and canopy (F) down and rest on fixture body. Then connect top rod (H) to bottom rod (I).
NOTE: Slide components down slowly to avoid damages. -
Hang fixture swivel ball (N) to the center of mounting plate (B) and secure using set screw (D) with provided wrench (E).
-
Cut excess wires, being sure to leave enough to reach the junction box.
-
Separate two sides of molded wire, and strip insulation on each 5/8″.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>