ZENEC ZE-RVC55LP License Plate Cam Instructions

: June 5, 2024
: ZENEC

Table of Contents

KEY FEATURES
DESCRIPTION:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MOUNTING INSTRUCTIONS
ZE-RVC55LP
LICENSE PLATE CAM

KEY FEATURES

Compact, high-resolution camera for license plate holder
Two different mounting solutions included in the set content
System design allows front- or rear- mounting and use
Detailed high contrast picture ideally suited for twilight conditions
Separable 3-part system cable, with cable lengths of 0.7m + 7.0m + 0.7m
Normal or mirror image picture output selectable

DESCRIPTION:

The ZENEC license plate cam model ZE-RVC55LP was developed for use on almost any license plate holder, allowing retrofitting of a great variety of vehicles. The picture can be outputted as a normal or mirror image, for mounting and utilization of this model as a front- or rearview camera. With two different mounting options, the ZE-RVC55LP is ideal for use on almost any vehicle. This product is compatible with a wide variety of 2-DIN A/V receivers of the aftermarket and the ZENEC E>GO product lineup, including ZENEC 2-DIN Infotainers and Naviceivers.

CAUTION:

Use the included connection cable exclusively. Altering or replacing it will void your warranty.
The camera is water- and dustproof and has been licensed according to the international standard IP69K. However, vehicle cleaning using high-pressure water and steam jet devices may still lead to damage of IP69 K-rated camera models by water intrusion. Keep a distance of at least one meter between the water nozzle and the camera housing.

MI Technical Specifications

Image device:| ¼”/ 6.4 mm Aptina ASX340 CMOS sensor
Lens focal length:| f1.5
TV system:| NTSC / 60 Hz
View angle:| 180°(D) x 140°(H) x 90°(V)
Native sensor resolution:| 680 (H) x 512 (V) pixels
Resolution of video-out:| > 420 TV lines
Frame rate:| 60 fields/sec.
Signal to noise ratio:| > 48 dB
Light sensitivity:| 0.5 Lux/F1.2/50IRE
Video output:| 1.0 Vp-p, 75 ohms CVBS
White balance:| Auto
Backlight compensation:| Auto
Gamma correction:| 0.45
Gain control:| Auto
Sync system:| Auto
Power supply:| 12 DCV (9 V —16 V)
Current consumption:| 40mA (DC12V) / ≤ 480mW
IP protection rating:| IP69K
Operating temperature:| -30°C—+75°C
|
---|---

There are two ways to install the ZE-RVC55LP:
Alternative 1: You can attach the camera with the enclosed aluminum bracket and the adhesive pad on the back of the license plate holder. The aluminum bracket can be adjusted by bending individually to the respective vehicle.
Alternative 2: Screw the camera directly onto the top of the license plate holder using the enclosed screws.
Drill a hole with a diameter Ø 6,5 mm and put the cable through it. The rubber seal must seal the hole completely.

10R-05 14733
ZENEC – Bohrturmweg 1 – CH-5330 Bad Zurzach – Switzerland
EU Legal Representative:
ACR S & V GmbH – Industriestraße 35 – D-79787 Lauchringen – Germany
Rev.D
www.zenec.com