Sabrent SP-FRSG POS Terminal and Barcode Scanner User Manual
- June 5, 2024
- Sabrent
Table of Contents
Sabrent SP-FRSG POS Terminal and Barcode Scanner
LAYOUT
TURN ON DEVICE : Hold down the POWER BUTTON until the device turns on.
TURN OFF DEVICE : Hold down the POWER BUTTON until the device brings up the shut-down menu. Select “POWER OFF” and proceed.
TURN OFF DISPLAY : Press the power button once. Alternatively, the device will automatically turn off the screen if left idle for a configurable amount of time. This setting can be found navigating to “Settings—Display—Sleep”.
TURN ON DISPLAY : Press the power button.
SIM CARD INSTALLATION
Remove the SI Ms and MicroSD tray. Place your SIM and memory cards as seen below.
CHARGING INSTRUCTIONS
Connect one end of the USB cable to the USB power adaptor and the other end to the USB Type-C connector at the bottom of the unit. Plug the USB charger into a wall outlet. The charging LED turns red when the device is charging. The LED turns off once the device is fully charged.
BATTERY OPERATION
This unit’s battery is a polymer battery and it is not removable. It should be
charged using only its original power adapter. Do not store battery in a hot,
humid, or corrosive environment. Do not break, pierce, or crack the battery.
Do not store battery when it is fully charged nor completely drained.
CONNECTING IT TO A COMPUTER
First you need to install the Android™ driver for WindowsTM, which you can download at www.sabrent.com. Once this is done, you will be able to simply connect your device to your PC using same USB cable that is used for charging the device.
NOTE ON LITHIUM BATTERY CARE
- Charge battery only with the supplied power adaptor.
- Do not store the device with the battery installed for long periods of time. If long time storage is required, first remove the battery from device. Do not store the battery fully charged. It is best to store a lithium battery when it is half-charged or around 60%.
- In the event of long time storage, after the first three months, the battery needs to be charged to 100%, then fully discharged to 0% and then recharged to 60% or 70% of its capacity. This process has to be repeated every three months if the battery is not in use. This will extend the life of the battery when it is not being used.
- Store battery in a dry and cool environment.
- Only recharge battery at 5′ to 45′ Celsius.
- Do not operate the device outside the recommended temperature range, which is between- 20′ and 60′ Celsius.
- Do not install a third-party battery into your Sabrent device.
Please contact our Technical Support Team for additional troubleshooting WWW.SABRENT.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>