MACROM M-AND.DAB DAB+ Receiver User Manual
- June 6, 2024
- MACROM
Table of Contents
ANDROID
DAB/DAB+
RECEIVER
USER MANUAL
M-AN.DAB
Warranty
Thank you for purchasing this Macrom product. Should your product need
warranty service, please return it to the shop where you buy it or to the
Macrom distributor in your country. The warranty does not cover damage due to
improper use and or installation, incorrect connections to power supply,
exposure to excessive humidity, unauthorized repair attempts or modifications.
Warning
Before starting the installation, disconnect the cable from the negative
battery terminal to avoid short circuits during installation. This product
must be installed properly by an authorized Macrom installer. Improper
installation can damage the unit and/or the vehicle. This product can only be
used inside the vehicle. Check electrical connections and driveability before
installing. The power of the received signal may vary depending on the
following causes:
– Recommended dimensions for installation do not comply.
– Shielded, reflective or darkened windows with film.
– Antenna cable overlap with other electrical wiring of the vehicle.
– Noise produced by the windscreen wiper.
– Direction of the transmission station with respect to the position of the
antenna.
Do not install the product on movable parts such as windor or door deflectors.
Installation of this product may not be suitable for certain types of
vehicles.
Specifications
Frequency 174-237MHz Band III, 1452-1492MHz Band-L
Impedance 50 Ohms
Gain 16-20dB (input power -30dBm)
Operation Voltage 5 Volts
30mA operation current
Product overview
Front view
Product location
For safety reasons, the antenna must be installed on the passenger side.
To ensure optimum reception, spacing the film antenna from the top of the
glass by 150mm and position it in more than 70mm from the side end of the
glass.
Spin any other aerial of at least 100mm.
NOTE :
Be sure to check the installation location of the film antenna.
The antenna can not be re-glued.
Left-hand drive installation
Product installation
- Before gluing the parts, advise you to clean surfaces with detergent (eg alcohol).
- Heat the surfaces to allow good adhesion of the
- components. Position the antenna respecting the
- recommended distance. Paste the foil for the ground
- connection to the front upright. Paste the amplifier and then the antenna film
- Make sure the antenna cable does not interfere with the airbag.
Left-hand drive installation
Product installation
- Remove the protective film from the foil for mass connection and apply pressure on it to evenly apply the surface to the upright.
- Gently remove the protective film during application and apply pressure on it to evenly apply the antenna to the glass.
DAB application
The DAB application is preloaded on the device.
Touch the DAB icon on the main interface to enter DAB mode.
You can also touch the DAB icon on the application page.
If you want to use another application related to the DAB function, make sure that it is compatible with the Android system and that the functions are supported correctly.
Installation
Connect the DAB module to the DAB antenna supplied in the package. Connect the micro USB to the DAB device and the USB to one of the USB sockets of the central unit.
Declaration of conformity
The manufacturer Aldinet S.p.A declares that the type of radio equipment –
DAB+ receiver, model M-AN.DAB, brand Macrom – complies with the 2014/53 / EU
Directive.
The full text of the EU Declaration of conformity is available at the
following internet address: www.macrom.it, or at
Aldinet S.p.A. Viale Colombo, 8 – 20090 Trezzano S/N (MI) Italy
Made in China
by Aldinet S.p.A.
Viale Colombo, 8 – 20090 Trezzano S/N (MI) Italy
The MACROM brand is a registered trade mark of ALDINET S.p.A.
ALDINET S.p.A
Viale C. Colombo, 8 – 20090 Trezzano s/N (MI) – Italy
Tel. +39 02 484781
www.macrom.it
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>