HEAVYS H1H Headphones Review Comparison User Guide

HEAVYS H1H Headphones Review Comparison

Power

On / Off

LED Color Code

• Pairing: Blue / Red Blinking
• Pairing Successful: Blue / Green Blinking (3s)
• Blue: BT Connection
• White: USB Audio
• Green: Analog Audio
• Red: Charging
• Red blinking: Battery Low

Bluetooth On / Off Pairing

• Pair New Device

Bluetooth Pairing Reset

• Reset Pairing Table

Analog Mode

Digital Wired Mode

• Digital Mode

Play / Pause

Volume Up / Down

• Volume Up / Down
• Volume + / –

Next Track

Previous Track

Phone Calls
Answer / End / Decline

Hell Blocker Mode
(Active Noise Cancelling) On / Off

• Activate Hell Blocker

Transparent Mode On / Off

• Activate Transparent Mode

Voice Assistant

• Activate Voice Assistant

Charge

Important Safety Instructions

Read all the instructions before using the product

1. To avoid accidental ingestion, keep the small parts away from small children and pets

2. Do NOT use the headphones at a high volume for any extended period

3. To avoid hearing damage, use your headphones at a comfortable, moderate volume level.
   Turn the volume down on your device before placing the headphones in your ears, then turn the volume up gradually until you reach a comfortable listening level. Long-term exposure to loud music or sounds may cause hearing damage. It is best to avoid high volume levels when using these headphones, especially for extended periods

4. Do not use these headphones when operating a motor vehicle, a bicycle, machinery or where your inability to hear outside sounds may present danger to you or to others

5. Using these headphones limits your ability to hear noises around you, regardless of listening volume. Please be cautious when using these headphones

6. Use caution and follow applicable laws regarding mobile phone and headphone use if using the headphones for phone calls while driving. Some jurisdictions impose specific limitations, such as single earpiece configuration, on the use of such products while driving

7. Do not drop the earphones, insert, or allow to be immersed in water

8. Use this product only with an agency approved power supply which meets local regulatory requirements (e.g., UL, CSA, VDE, CCC)

9. Using an AC adapter or charger from a non-certified manufacturer could result in fire or personal injury

10. Do not use headphones that are damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury to persons

11. Do not disassemble the headphones. Incorrect reassembly may result in risk of fire or injury to persons

12. Do not open, crush, or expose the headphones to fire, or excessive temperature. Exposure to fire or temperature above 212° F, 100° C may cause explosion

13. Have servicing performed by a qualified repair person using only identical replacement parts.

14. This product contains magnetic material. Consult your physician on whether this might affect your implantable medical device.

15. Do NOT make unauthorized alterations to this product.

For any questions or concerns contact: Support@heavys.com.

FCC STATEMENT

Regulatory Compliance I/III

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Heavys Inc. could void the user’s authority to operate this equipment.
This device complies with part 15 of the FCC Rules and with Industry ISED license exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This device complies with FCC and Industry ISED radiation exposure limits set forth for general population. It must not be co-located or be operating in conjunction with any other antennas or transmitters.
FCC ID: 2BAOA-H1H
Model: HIH

Regulatory Compliance I|/III

Management Regulation for Low-power Radio-frequency Devices
Article XII
According to “Management Regulation for Low-power Radio-frequency Devices” without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting power, or alter original characteristic as well as performance to an approved low power radio-frequency devices.
Article XIV
The low power radio-frequency devices shall not influence aircraft security and interfere legal communications; if found, the user shall cease operating immediately until no interference is achieved. The said legal communications means radio communications operated in compliance with the Telecommunications Act.
The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM radio wave radiated devices.

Regulatory Compliance I|I/III

• Heavys Inc. hereby declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and all other applicable EU directive requirements.
• The complete declaration of conformity can be found at:
• https://www.heavys.com/support/declaration-of-conformity/
• For Europe: Frequency band of operation 2400 to 2483.5 MHZ
• Bluetooth: Maximum transmit power less than 20 dBm EIRP
• Bluetooth Low Energy: Maximum power spectral density less than 10 dBm/MHz EIRP DON’T attempt to remove the rechargeable lithium-ion battery from this product. For the exchange, contact HEAVYS Inc. Service growl@heavys.com or a qualified specialist.
• Please dispose of used batteries properly, following local regulations.
• Do not incinerate.
• This symbol means the product must not be discarded as household waste and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling help protect natural resources, human health, and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product. Removal of the rechargeable lithium-ion battery in this product should be conducted only by a qualified professional.
• EU Importer: HEAVYS / Im Wiesengrund 2 / 31303 Burgdorf / Germany

Specifications

Heavys Inc., and other marks are registered trademarks of Heavys, Inc. All rights reserved.

• Driver diameter: 2x 38mm 2x12mm.
• Impedance: 42 Ohms.
• THD: <0.5% @lkHz 100 dB SPL
• Battery: 3.7V, 880mAh, 3.26Wh. Bluetooth 5.1,
• Frequency Band: 2402MHz – 2480 MHz,
• Weight: 308g.

Contains Li-ion battery. Battery must be recycled or disposed of properly.

SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, Heavys Inc. declares that the radio equipment type [Model: HIH] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: heavys.com /product-documents.

CONTACT

• USA
• Heavys, Inc.
• 1216 Broadway
• New York City, NY
• 10001 U.S.A.
• Heavys.com.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>