DELTA RS2300 Single Bike Ceiling Hoist With Straps Instruction Manual
- June 5, 2024
- Delta
Table of Contents
DELTA RS2300 Single Bike Ceiling Hoist With Straps
Parts
- x1 — Single Pulley (Back)
- x1 — Double Pulley (Front)
- x7 — Screws
- x2 — Pulley Hooks
- x1 — Cord Cleat
- x1 — Cord
- x2 — Strap
IMPORTANT
IT IS RECOMMENDED THIS ITEM BE INSTALLED BY A COMPETENT PROFESSIONAL
- Determine the correct distance required between the two pulley hooks (e.g. handlebars to back of seat on a bicycle).
- Locate the ceiling joist. Transfer the distance measurement (Step 1) so that the pulleys line up to the correct distance along the joist (Note: It is also possible to mount the pulleysrst onto a board which can then be securely mounted to joists as illustrated).
- Securely tie a double knot in the end of the cord and feed the remaining cord throught the hole on the end of the pulley unit that does not have the cord locking mechanism. The knotted end will then be between the ceiling and the pulley bracket.
- Using screws provided, carefully mount each pulley into the ceiling joist at the correct distance so the hooks will line up (as measured in 1). Important; ensure that the 2 screws on each pulley are securely mounted into the joist. Pre-drilling 1/8” pilot holes will make this job easier.
- Thread the cord through the pulleys as shown. Be sure to carefully thread the cord down through both parts of the locking mechanism.
- Mount the cord cleat at a safe height out of reach of small children and screw directly into a stud using two wood screws supplied. When item is raised to the desired height, the excess rope should be stored around the cleat Do Not Cut Excess Cord.
USAGE INSTRUCTIONS
Raising an item
Ensure the hooks are properly secured on the item and the cord is not twisted
before pulling on the cord. The auto-locking device will hold the item
suspended with each pull. Once hoisted to the correct height, wrap the excess
cord securely around the cleat.
Lowering an in item
Keeping the tension in this direction, slowly let the cord out as the item
lowers. Once low enough, remove the item from the hooks and wrap the cord back
on the cleat.
Using Strapsaps
First ensure the bulky item is properly secured, tightening the straps as
needed at the buckle. Secure the loops onto all of the hooks before hoisting
the item. 
Need help?
Email us at service@designbydelta.com & we’ll help solve your issue. Delta Cycle Corporation 36 York Avenue, Randolph, MA 02368 USA / 800-474-6615 / www.designbydelta.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>