ONFORU C15UVW UV LED Flood Light Instruction Manual
- June 5, 2024
- ONFORU
Table of Contents
C15UVW UV LED Flood Light
Instruction Manual
MODEL:
C15UuVw C30UuVw Cc6ouvw c100uvw
UV LED FLOOD LIGHT
Product Manual
UK 220-240V AC
SAFETY INFORMATION
**** Disconnect the power supply before attempting any work on the unit!
- Installing these units involves work on the mains voltage supply; installation must therefore be carried out professionally in accordance with the appliance national wiring regulations and electrical operating conditions.
- Never plug the light in with wet hands in case of electric shock.
- Check all components for damage, do not use the product if it is damaged.
- To ensure the product can work normally, please use it in the voltage within the range on the lamp label.
- Do not install the unit on (normally) flammable surfaces.
- The floodlight enclosure heats up when the light is on. Only adjust the angle of the LED panel once it has cooled down. Do not look into the LED light at a short range or for any prolonged period(>5 min).
- Do not alter or change parts of the light at will, in case of the accidents such as breakage, fall, electric shock, fire, etc.
- The light is IP66 waterproof, but the plug is non-waterproof. Please connect the plug indoors or connect to a socket that provides IP65 protection.
- This is a UV lamp. Human eyes can only detect a small part of the light, so it will appear a little dim when it lights up. Since it is mainly used for reaction and other purposes. If you just want to buy a violet light, this UV lamp is not recommended for you.
PARAMETER
| A. 140x32x90 mm 5.51×1.26×3.54in
B.166x36x116mm 6.54×1.42×4.57in
C.240×41.5x160mm 9.45×1.63×6.3in
D.300×46.5x200mm 11.81×1.83×7.87in
---|---
| 100-120V AC 60Hz 220-240V AC 50Hz
| 385-400nm, UVA Level
| IP66
| -25°C – 40°C
**COMPONENTS AND STRUCTURE
**
- Tempered Glass Lid
- LED Light Source
- Lamp Bracket
Note: Cord – type Y attachment.
For type Y attachment: If the external flexible cable or cord of this
luminaire is damaged, it is exclusively replaced by the manufacturer or his
service agent or a similarly qualified person in order to avoid a hazard.
Instructions for the remote control
ON/OFF | Turn on/off |
---|---|
UV | UV light |
WHITE | White light |
B+/B- | Brightness adjustment, ten levels |
S+/S- | Speed adjustment, ten levels |
FLASH | Flash mode |
STROBE | Strobe mode |
2H/4H/8H | Timing |
NOTE
- Make sure that the distance between the light and the object being lit is more than 1 meter, so as to avoid high temperature caused by short distance.
- Caution, risk of electric shock.
- Earth wire is required for connection for electric safety.
Non-User Replaceable Light Source
The light source contained in this flood light shall only be replaced by
the manufacturer or his service agent or a similar qualified person.
Limitations of Indoor and Outdoor Use
- This light is waterproof and dustproof. It is protected against rain, but it cannot be immersed in water.
- The mounting position of this light should be able to bear at least 10 times as heavy as the light.
- This light should be used in conditions with sound heat dissipation. The working temperature of it should be less than 45°C. Overhigh working temperature will cause serious lumen depression and affect the lifespan of the light.
INSTALLATION STEPS
Step 1 : According to the spacing (see the “A” part of the picture) of
two screw bits on the LED Light bracket, drill two mounting holes.
Step 2 : Put the bracket onto the prepared mounting holes and then screw
it on.
Step 3 : Adjust the beam direction as you like, and then plug it into the
main socket.
OPERATION & MAINTENANCE
- Prior to cleaning the light, make sure it has been disconnected from the power supply.
- The unit is not suitable for burglar alarm systems as it is not tamperproof in the manner prescribed for such systems.
- Never use any chemicals or corrosive substances for cleaning.
DISPOSAL
Electrical and electronic equipment, accessories, and packaging must be
recycled in an environmentally compatible manner.
Do not dispose of electrical and electronic equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste Electrical and Electronic
equipment and its implementation in national law, electrical and electronic
equipment no longer suitable for use must be collected separately and recycled
in an environmentally compatible manner.
Manufacturer / Hersteller:
Shenzhen ShiMeng ZhiTuo KeJiYou XianGongSi
Address: qianwanyilu 1hao A dong 201 shiqianhai Shenyang hezuoqu Shenzhen,
Guang
Dong, 518000, CN
support@onforuled.com
www.onforuleds.com
BellaCocool GmbH
Pettenkoferstraße 18, 10247, Berlin, Germany
support@onforuled.com
MDH LIGHTING LTD
UNIT G25 WATERFRONT STUDIOS 1 DOCK ROAD
LONDON UNITED KINGDOM E16 1AH
support@onforuled.com
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>