Westinghouse WGen5300v Portable Generator User Guide
- June 4, 2024
- Westinghouse
Table of Contents
Westinghouse WGen5300v Portable Generator
BEFORE STARTING
Add engine oil.
- Remove oil fill plug/dipstick.
- Retirer le bouchon du goulot de remplissage/la jauge.
- Using the supplied 4-cycle engine oil and funnel, slowly add engine oil to the engine until full.
- Replace oil fill plug/dipstick.
Add unleaded gasoline to gas tank.
- Unscrew gas cap on top of tank and insert a clean funnel into the tank.
- Slowly add gasoline into the fuel tank. The gasoline level should NOT be higher than the filler neck.
- Secure gas cap.
STARTING PROCEDURE
- Make sure the generator is OUTSIDE in a well-ventilated dry area and FAR AWAY from any doors, windows, or vents.
- Check fuel and oil levels.
- Make sure nothing is plugged into power outlets.
- Make sure the circuit breakers are properly set to operating.
- Move the fuel valve to the ON position.
- Move the choke lever to the ON position. If the engine is warm turn the lever to the OFF position.
- Switch engine control switch to the RUN position.
- Manual Start: Firmly grasp and pull the recoil handle slowly until you feel increased resistance. At this point, apply a rapid pull while pulling up and slightly away from the generator.
- After the engine starts, gradually move the 9 choke lever to the OFF position.
- Plug in electronic devices.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>