anslut 019713 Balloon Shaped Solar Lighting LED Instruction Manual
- June 4, 2024
- anslut
Table of Contents
019713 Balloon-Shaped Solar Lighting LED
Instruction Manual
SOLAR CELL LED LIGHTING
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for
future reference. (Translation of the original instructions)
Important! Read the user instructions carefully before use. Save them for
future reference July reserves the right to make changes. For the latest
version of operating instructions, see www.jula.com
2021-12-16
© Jula AB
JULA AB, BOX 363, SE-532 24 SKARA
SYMBOLS
Read the instructions.
Approved in accordance with the relevant directives.
Recycle discarded products in accordance with local regulations.
TECHNICAL DATA
| Battery type (rechargeable) | AAA |
|---|---|
| Battery technique | NiMH |
| Battery voltage | 1.2 V |
| Battery capacity | 300 mAh |
| Light source | LED |
| Color temperature | 3000 K |
| Colour tone | Warm white |
| Luminous flux | 0.6 lm |
| Output | 62 mW |
| Protection rating | IP44 |
| Size | H114 x Ø26 cm |
DESCRIPTION
Hangable, balloon-shaped, and colorful solar cell light that spins in the wind. The lamp has two warm white LED bulbs that produce a soft light. Runs on a rechargeable AAA battery (included).
- Solar cell panel
- LED
FIG. 1
SOLAR CELL-POWERED LIGHT
- The product runs on solar energy via the built-in solar panel.
- The solar panel converts solar energy to electrical energy, which is used to charge the rechargeable NiMH battery.
- The light switches on automatically when it goes dark and switches off in daylight. How long the light stays on depends on how long the solar panel has been exposed to sunlight.
– Long exposure to sunlight produces longer lighting up.
– For best functionality, place the product so that it is exposed to sunlight and is therefore charged for as long as possible.
– With maximum exposure to sunlight the light will shine for up to 8 hours.
USE
- Carefully remove all the parts from the packaging.
- Start the product with the power switch (1). FIG. 2
- Place the product in the required place.
NOTE:
- Keep sharp objects away from the surface of the solar panel to prevent scratching and damage.
- The functionality of the product can be checked by covering the top of the solar panel – the light should go on if the product has started.
- It is difficult to see the LED light in bright ambient light. The product works best in the dark. This does not mean that the product is not working.
- For best functionality, allow the product to charge for one day before using it for the first time.
**REPLACING THE BATTERY
**
Follow the instructions to replace the rechargeable AAA battery (NiMH).
FIG. 3
- Unscrew the screws on the bottom of the casing with a screwdriver and open the battery cover.
- Replace the battery with a new one of the same type (rechargeable AAA battery, 1.2 VDC, 300 mAh, NiMH).
- Replace the battery cover and firmly tighten the screws.
NOTE:
- Do not mix old and new batteries.
- Do not mix alkaline batteries with ordinary batteries or rechargeable batteries (NiCd, NiMH, etc.).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>