CONCORD T95 Brown Glass Table Lamp Set Instruction Manual
- June 4, 2024
- CONCORD
Table of Contents
CONCORD T95 Brown Glass Table Lamp Set
STEPS TO ASSEMBLE THE LAMPSHADE
- Take out the lampshade and 2 wrought iron frames
- Unfold the fabric lampshade
- Fix the two frames with velcro along the edge of the lampshade
- Mount the harp and install the bulb (Not included)
- Tighten the finial to secure the lampshade
Assembly & Installation Instructions
Dear Customer:
Thank you for your business! If you have any questions or problems, please
send us an email to [email protected] or call
us at 870-949-8466. We will do
everything possible to make you completely satisfied with your purchase.
Product reviews help future customers to make their purchase decision. You are
encouraged to share your experience by leaving a short product review on the
platform where you bought this product.
Thank you
Zgear Team
Warning: If any special control devices are used with this fixture,
follow the instructions carefully to assure full compliance with N.E.C.
requirements. If there are any questions, contact a qualified electric
contractor.
Warning: California Residents Proposition 65 This product contains lead,
a chemical known to the state of California to cause cancer and birth defects
or other reproductive harm. Do not place the product in your mouth. Wash your
hands after handling this product.
Caution: It is highly recommended to get an electrician to install this
light. Please make sure to turn the electricity off at the main circuit
breaker before beginning installation. All glass is fragile. Use care when
handling glass component(s) and/or lamp(s)
WIRE CONNECTION DIAGRAM
Wires meeting safety standards are required to connect the electical circuit
CAUTION: Risk of fire
Please read all instructions carefully. Before you proceed to install, make
sure that the power supply is turned off and remains off until installation is
completed.
PARTS INCLUDED
- Unpack all parts from cartons carefully.
- Carefully pull-out excess power cord from the lamp base while assembling to prevent the cord from becoming twisted.
- Tighten the lamp socket(B)into the body (A)until tight.
- Place the harp(D)onto the saddle(C).
- Place the shade(E)onto the harp(D).
- Tighten the finial(F)into the harp(D)until tight.