aigo Sport Bluetooth Headset User Manual

: June 7, 2024
: aigo

Table of Contents

Warnings
How to wear
How to pair
How to control
How to deal with discarded devices
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

S55
SPORT BLUETOOTH HEADSET

USER MANUAL

Product: S55
Driver diameter:9.2mm
Bluetooth version: V4.2+EDR
Operation distance:10m
Music time: 7-8 hours
Battery capacity: 100mAh
Impedance: 25Ω±15%
Voice prompt: English
Speaker Sensitive:93dB±3dB
Frequency Response:20Hz~20KHz
Compatible for: IOS, Android, PC, etc.

Warnings

Do not use the earphone while driving or cycling.
Do not attempt to modify, crack, jack or sunk the earphone into water.
Do not expose the earphone to extreme temperature and moist dirty environment.
Avoid to keep playing earphone too long time with a high volume.
Keep the earphone & its accessory out of reach of children.

How to wear

For the best audio experience, please try the earplugs and select the most suitable for your ears.
Carefully wear the earphone with L mark in your left ear, and the other one with R mark in your right ear.
Twist the earphone up into the ear canal while inserting, until outside noise is blocked out.
Important:
If there seems to be lack of low frequency response or lower volume, this means that the earphones earplugs are not forming a tight seal, greatly push the earphone deeper into the ear canal or try suitable earplugs.
Warning:
Do not push the earphone sleeve beyond the ear canal opening.

How to pair

Power on
Long press the power button for about 3 seconds, hearing the alert tone”power on”and the LED blue light flash for 2 seconds, it means the Bluetooth earphone is worked.
Pairing
Long press the power button for about 5 seconds, hearing the alert tone”power on”or”pairing”, it means the earphone in the pairing mode. Then turn on the Bluetooth function of the phone or other device, and connect the Bluetooth signal, hearing the alert tone”connected”, it means paired successfully.
Power off
Long press the power button about 3 seconds, hearing the alert tone”power off”and the LED red light flash 2 seconds, it means the Bluetooth earphone is turned off.

How to control

Calling in:
Short press: answer
Long press: reject
Double press: hang up
Calling Back:
Double press: call back to the Last call
Music:
Short press: play/pause (during music playing mode)
Power on/ off:
Long press about 3 seconds

How to deal with discarded devices

For proper treatment to avoid harmful effect on human health and environment. Please contact your local municipality, or your waste disposal service or the point of sale where you purchased the item.

Manufacturer for: Aigo International Co., Ltd.
Manufacturer by: Beijing EROS Technology Co., Ltd.
Address: Room 321, 3rd Floor, Building 1., No 26,
Lianhuachi Xili, Haidian District, Beijing, china

Website: www.aigo.com
E-mail: customerservice@aigo.com
Made in China

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment.