SUPERATV IN-WS-CA-MAVR Scratch Resistant Vented Full Windshield Instruction Manual
- June 1, 2024
- SUPERATV
Table of Contents
SUPERATV IN-WS-CA-MAVR Scratch Resistant Vented Full Windshield
kit Contents
- Do not discard packaging until product has been successfully installed.
- Super ATV does not recommend keeping Windshield installed while transporting on an open air trailer. Remove or secure with straps.
- Sku WS-CA-MAVR-V shown in installation illustrations.
- This item is not returnable if the protective film has been removed.
- Test fit to the cage to confirm fitment before removing film.
INSTALLATION INSTRUCTIONS
Windshield Cleaning
- Do not use Rain-X®, Plexus® or any other protector, wax, or polish.
- Do not use window cleaning fluids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, etc).
- Never use abrasive cleaners, abrasive pads, or gritty cloths.
- Do not use a windshield wiper blade or install a motorized windshield wiper
- Never use razor blades, scrapers, squeegees, brushes, etc.
-
Thoroughly rinse Windshield to float off dirt and mud.
-
Using a soft cloth, or microfiber cloth, clean Windshield with warm water and a gentle detergent. Baby shampoo, rubbing alcohol, or hand washing soap can also be used.
-
To prevent water spots, use a chamois to blot Windshield dry.
-
Reinstall Roof hardware after Windshield has been installed.
-
Install Upper to Lower with hardware shown; tighten.
To ease installation, soak Seal in hot water before cutting or installing to increase flexibility. -
Install Seal.
-
Install Upper Bracket – R to Cage with hardware shown; do not tighten.
-
Install Clamp to Cage with previously removed Clamp hardware; do not tighten. Reinstall Cover.
-
Install Lower Bracket – R to Clamp with hardware shown; do not tighten.
-
Repeat for driver side components.
-
Install Windshield assembly to Brackets with hardware shown; do not tighten.
-
Align to machine and tighten all hardware.
-
Thread Straps through slots in Upper and secure to Cage. Pull tight.
-
Liability Statement
Super ATV® products are designed to best fit user’s ATV/UTV under stock
conditions. Adding, modifying, or fabricating any factory or aftermarket parts
will void any warranty provided by Super ATV® and is not recommended. Super
ATV® products could interfere with other aftermarket accessories. If user has
aftermarket products on machine, contact Super ATV® to verify that they will
work together.
Although Super ATV® has thousands of satisfied customers, user should be aware
that installing lift kits, long travel, or suspension kits, tires, etc. will
change the ride of machine and may increase maintenance and part wear.
Operating any off-road machine while, or after, consuming alcohol and/or drugs
increases risk of bodily harm or death. No warranty or representation is made
as to this product’s ability to protect user from severe injury or death.
Super ATV® urges operators and occupants to wear a helmet and appropriate
riding gear at all times.
By purchasing and installing Super ATV® products, user agrees that should
damages occur, Super ATV® will not be held responsible for loss of time, use,
labor fees, replacement parts, or freight charges. Super ATV®, nor any 3rd
party, will not be held responsible for any direct, indirect, incidental,
special, or consequential damages that result from any product purchased from
Super ATV®. The total liability of seller to user for all damages, losses, and
causes of action, if any, shall not exceed the total purchase price paid for
the product that gave rise to the claim.
Super ATV® will warranty only parts provided by Super ATV®. Any damage or
problems with OEM housings, bearings, seals, or other manufacturers’ products
will not be covered by Super ATV®. Super ATV® parts and products are not
warrantied if item was not installed properly, misused, or modified.
Installing, adding, modifying, or fabricating any factory or aftermarket
product to your ATV/UTV may violate certain local, state, and federal laws. Be
advised that laws vary depending on town, city, county, state, etc. Use of
certain products on public streets, roads, or highways may be in violation
law. The Buyer is solely and exclusively legally and personally responsible
for any violation of he law by the installation or use of the product. You
must abide by all local, state, and federal laws, including but not limited to
vehicle safety, traffic laws, and ordinances. It is your responsibility to
know the laws and how they apply to you.
The Buyer is responsible to fully understand the capability and limitations of
his/her vehicle according to manufacturer specifications, warnings and
instructions and agrees to hold Super ATV® harmless from any damage resulting
from failure to adhere to such specifications, warnings and/ or instructions.
The Buyer is also responsible to obey all applicable federal, state, and local
laws and ordinances when operating his/her vehicle while using this product,
and the Buyer agrees to hold Super ATV® harmless from any violation thereof.
CUSTOMER SUPPORT
sales@superatv.com
1-855-743-3427
www.superatv.com
8:00am – 8:00pm
EST M-Th
8:00am – 7:00pm EST Friday
9:00am – 2:00pm EST Saturday
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>