Ancerre DESIGNS DAF3ZnaL9Ao Mirrors and Cabinets Instruction Manual
- June 1, 2024
- Ancerre DESIGNS
Table of Contents
MANUAL INSTRUCTION
Operating Instruction
A. Turn on/off lighting:
Short press button to start light working. Hold on the button (>2s) to adjust
the brightness, dimming from 10%-100%.
B. Defogger:
Press button will light up and start working, light off will stop working. It
will turn off automatically after 60 minutes work.
C. CCT changing:
Short press button will change the color temperature 3000K or 6000K.
D. How to adjust the digital clock:
Hold down the button for more than 2s and enter programming mode. When the
digits flicker, short press the button again to adjust the digits. Hold on the
button more than 2s can move the step from hours to minutes. At the end hold
down the button more than 3s will saving the setting.
Care & Maintenance
NOTE: Use warm soap water and a soft, damp, lint-free cloth to clean the
mirror.
Wipe dry with another clean cloth. Glass cleaner can be used on the mirror
surface when required. Avoid scourers, abrasives and chemical cleaners as they
can damage the glass and the frame.
In hard water areas, limescale may deposit the glass. Regular cleaning will
minimize this problem. If this build-up becomes increasing difficult to
remove, apply a small amount of white vinegar on the area.
Do not attempt to cut the glass.
Do not hit the glass with hard or sharp article.
Installation Instruction
Please read follow warm tips before installation:
-
Power off electrical before installation. Use voltage detector to make sure.
Verify the circuit breaker is turned off & lock it in case someone try to turn it on. -
If you’re NOT experienced in installing electrical wiring, then hire a processional electrician. Your safety is more important then saving a few dollars.
-
Avoid water at all times when working with electricity. Never touch or install any electrical equipment or circuits with wet hands.
-
Tools you will need: voltage tester, wire cutters, wire and cable strippers, needle nose pliers, continuity tester, and wire closure.
-
Wear Safety Glasses and Protective Clothing to protect you from sparks.
Required Tools:
Installation Instructions:
Installation Manual For Surface Mount
| ATTENTION: Ensure that power is off at the fuse box or circuit breaker
before installation.
---|---
| Step 1: Mark the position of the screw through the wall mounted brackets on
the wall, make sure that the brackets is leveled horizontally.
| Step 2:
Drill the holes.
| Step 3: Tap
the six wall anchors provided into the holes drilled in step 2.
| Step 4:
Secure the upper & bottom wall mounted bracket bracket with the screws
provided.
| Step 5: Use the 3-ports wire connector provided to connect the power cord
and hang the mirror up to the wall mounted brackets.
| Step 6:
Open the door. push the glass shelf into the plastic clip secured in the
cabinet and secure the side mirror with the screws provided.
Installation Manual For Recessed Mount
| Step 1: Disassemble the door.
---|---
| Step 2: Cut the wall opening following above dimensions.
| Step 3: Use the 3-ports wire connector provided to connect the
power cord.
| Step 4: Push the cabinet into the wall opening.
| Step 5: Secure the cabinet to the wood studs with the screws provided.
| Step 6: push the glass shelf into the plastic clip secured in the cabinet.
| Step 7: Assemble the door.
Push and secure the cable to the socket secured in the cabinet.
www.ancerredesigns.com
Email: orders@ancerre.com
Customer Service: 888.830.8828
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>