Airpura P700 Germs, Mold and Chemicals Reduction Air Purifier User Guide

June 4, 2024
Airpura

Airpura P700 Germs, Mold and Chemicals Reduction Air Purifier

Airpura-P700-Germs,-Mold-and-Chemicals-Reduction-Air-Purifier-
product

To open the filter chamber

Airpura-P700-Germs,-Mold-and-Chemicals-Reduction-Air-Purifier-
fig-1

  • Turn over the Airpura
  • Remove the 4 retaining screws
  • Take off the cover
  • Remove the gasket
  • Position the Prefilter inside the filter chamber
  • Place a felt gasket at the bottom of the filter chamberAirpura-P700-Germs,-Mold-and-Chemicals-Reduction-Air-Purifier-fig-2
  • Unfold the filter slider (Supplied with replacement filters or on request Part#6F 001)
  • Roll it into a spiral
  • Insert the tube into the filter chamber inside the Prefilter
  • Let the spiral open to fill the opening
  • Open the top of the spiral to make a slight funnelAirpura-P700-Germs,-Mold-and-Chemicals-Reduction-Air-Purifier-fig-3
  • Insert the Carbon canister into the funnel and hold it straight
  • Let the canister slide down the filter slider
  • Pull the filter slider up out of the cavity using both hands and let the canister slide to the bottom of the cavity
  • Remove the filter slider and fold it for further use
  • Slide in the Hepa filter

To close the filter chamber

Airpura-P700-Germs,-Mold-and-Chemicals-Reduction-Air-Purifier-
fig-4

  • Replace the gasket
  • Position the indentation in the cover into the center of the HEPA filter
  • Replace the 4 screws and tighten
  • Turn the Airpura back on casters

TO BEGIN USING YOUR AIRPORT

  • Inspect the exterior of your Airpura to verify there is no damage from shipping.
  • If any damage is noted, please follow the instructions from the distributor returns policy.
  • Wipe the unit with a damp cloth to remove any dust from the packaging
  • Plug the unit into a regular grounded 110-volt outlet 2 Turn the unit on
  • Turn on the unit to MAX and allow it to run for at least 30 minutes
  • Set the variable speed control to the level you wish.

Always maintain a humidity level of 40% in your home to ensure the unit is operating at optimal levels. When using a purifier with a dehumidifier, please keep the dehumidifier at least 6 feet away. It is recommended to run your purifier at low speeds, 24 hours a day, 7 days a week. Running it at a low speed allows for a maximum dwell time of chemicals and VOCs in the air through both the carbon and HEPA filters thus delivering superior filtration.

FILTER MAINTENANCE AND REPLACEMENT

The Prefilter: Can be vacuumed from the exterior of the unit once a month or more often. Should be replaced at least after 12 months of use.

To vacuum the Prefilter

  • Use the brush attachment on your vacuum cleaner
  • Vacuum slowly around the mesh surface of the filter chamber

IMPORTANT SAFETY NOTE

  • Please ensure the air purifier is turned OFF when plugging into a power source.
  • Failure to do so may result in motor potentially stalling and/or burning.

Replacing the UV bulb

  • Open the filter chamber following the instructions
  • Pull the bulb upward out of the connector
  • Push the replacement bulb firmly into the connector
  • Close the filter chamber following instructionsAirpura-P700-Germs,-Mold-and-Chemicals-Reduction-Air-Purifier-fig-8
  • Titanclean 18-20 months
  • HEPA 600RVHU Filter
  • (99.97 % efficient @ 0.3 Microns) 3 to 5 years
  • P714: HEPA 14 Filter
  • (99.99% efficient @ 0.3 Microns)
  • P700+: HEPA 600 Filter w/ TiO2 (99.97% efficient @ 0.3 Microns)
  • P714+: HEPA 14 Filter
  • (99.99% efficient @ 0.3 Microns) + TiO2
  • UV bulb 18-20 months
  • Poly Prefilter 600 2-pack 12 months
  • 18 lbs, Coconut Shell Carbon Filter (100% Blend) 24 months

Technical specifications

Particle removal

  • Over 100 ft2 true HEPA
  • (Measured only 1 side)
  • 12 pleats per inch
  • Pleats warm rolled with separators

Activated carbon filter

  • 18 lbs carbon filter
  • 13″H X 13.25″OD X 9″ID

Carbon Bed

  • 2” deep X 570 sq. surface

Air Flow 635 cfm

  • More cfm than any other home unit available

Prefilter

  • 570 in2 x 1 in

Housing

  • Powder coat steel

Size

  • 23 in x 15 in

Weight

  • 35 lbs total

Watts

  • 120 on high / 40 on low

Sound Level

  • 30.2* db on low (at 6 feet)
  • 63.0 db on high (635 cfm)*at test conditions

Voltage options

  • 115 or 220 volts

Air purifiers models and filter configurations

| Prefilter| Particule| Carbon
---|---|---|---
Alternates| Cotton Prefilter TarBarrier Prefilter| | 18 lbs anthracite carbon filter (100%)
Upgrade| | HEPA 14 Filter (99.99 %

efficient @ 0.3 Microns) ULPA Filter (99.9999 %

efficient @ 0.1 Microns)

| 18 lbs impregnated carbon

18 lbs carbon (17% potassium permanganate carbon, 83% coconut shell

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals