Airpura T700 Tobacco Smoke Air Purifier Instruction Manual

T700 Tobacco Smoke Air Purifier
Instruction Manual

T700 Tobacco Smoke Air Purifier

Inspect the exterior of your Airpura to verify there is no damage from shipping.
If any damage is noted, please follow the instructions from the distributor returns policy.
Wipe the unit with a damp cloth to remove any dust from packaging
Plug the unit into a regular grounded 110-volt outlet
Turn on the unit to MAX and allow it to run for at least 30 minutes
Set the variable speed control to the level you wish
The most efficient way to use your Airpura for regular air quality maintenance is to run it at a low speed 24 hours a day 7 days a week.
Always maintain a humidity level of approximately 40% in your home to ensure the unit is operating at optimal levels. When using a purifier with a dehumidifier please keep the dehumidifier at least 6 feet away.

FILTER MAINTENANCE AND REPLACEMENT

The Prefilter
Can be vacuumed from the exterior of the unit once a month or more often.
Should be replaced at least after 12 months of use
To vacuum the Prefilter
Use the brush attachment on your vacuum cleaner
Vacuum slowly around the mesh surface of the filter chamber
IMPORTANT SAFETY NOTE
Please ensure the air purifier is turned OFF when plugging into a power source.
Failure to do so may result in motor potentially stalling and/or burning.

Air purifiers models and filter configurations

| Prefilter| Carbon
---|---|---
Alternates| Cotton Prefilter
Poly Prefilter| 26 lbs  Anthracite Carbon Filter (100 % Blend)
Upgrade| | 26 lbs Impregnated Carbon Filter (17% KI/
Potassium Iodide, 83% Coconut Shell Carbon)
26 lbs Impregnated Carbon Filter (35/65 % Blend: KI/
Potassium Iodide, Coconut Shell Carbon

Technical specifications

Tobacco smoke odor, and chemical control
26 lbs activated Carbon
13″H x 13.25″OD x 7.5″ID
Carbon bed
3 in deep x 570 in² surface
Tar removal
Special TarBarrier filter
570 in² x 1 in deep
Particle suppression
HepaBarrier
Air Flow 635 cfm
More cfm than any other home unit available
Housing
Powder coat steel
Size
23 in x 15 in
Weight
49 lbs total
Watts
120 on high / 40 on low
Sound Level
30.2 db on low (at 6 feet)
63.0 db on high (635 cfm)
at test conditions

To open the filter chamber

Turn over the Airpura| Remove the 4 retaining screws| Take off the cover| Remove the gasket| Position the Prefilter inside the filter chamber| Place a felt gasket at the bottom of the filter chamber

Unfold the filter slider
(Supplied with replacement
filters or on request
Part#6F 001)| Roll it into a spiral| Insert the tube into the filter| Let the spiral open to fill
the chamber inside the Prefilter the opening| Open the top of the spiral to make a slight funnel
Insert the Carbon canister into
the funnel and hold it straight| Let the canister slide down the filter slider| Pull the filter slider up out of the cavity using both hands and let the canister slide to the bottom of the cavity| Remove the filter slider and fold it for further use| Slide in the Hepa filter

To close the filter chamber

Replace the gasket| Position the indentation in the cover
into the center of the HEPA filter| Replace the 4 screws and tighten| Turn the Airpura back on casters

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>