Airpura R700 Air Purifier Instruction Manual
- June 4, 2024
- Airpura
Table of Contents
R700
OPERATING & FILTER REPLACEMENT DIRECTIONS
TO BEGIN USING YOUR
AIRPURA
Inspect the exterior of your Airpura to verify there is no damage from
shipping.
If any damage is noted, please follow the instructions from the distributor
returns policy.
Wipe the unit with a damp cloth to remove any dust from packaging Plug the
unit into a regular grounded 110 or 220-volt outlet Turn on the unit to MAX
and allow it to run for at least 30 minutes Set the variable speed control to
the level you wish The most efficient way to use your Airpura for regular air
quality maintenance is to run it at a low speed 24 hours a day 7 days a week.
Always maintain a humidity level of 40% in your home to ensure the unit is
operating at optimal levels. When using a purifier with a dehumidifier, keep
the dehumidifier at least 6 feet away.
FILTER MAINTENANCE AND REPLACEMENT
The Prefilter
Can be vacuumed from the exterior of the unit once a month or more often.
Should be replaced at least after 12 months of use
To vacuum the Prefilter
Use the brush attachment on your vacuum cleaner Vacuum slowly around the mesh
surface of the filter chamber
IMPORTANT SAFETY NOTE
Please ensure air purifier is turned OFF when plugging into a power source
Poly Prefilter 600 2-pack
12 months
HEPA 600RVHU Filter (99.97 % efficient @ 0.3 Microns)
3 to 5 years
HEPA with ULPA
99.9999% efficient @0.1 microns
3 to 5 years
18 lbs Carbon Filter
12-24 months
To open the filter chamber
Turn over the Airpura| Remove the 4 retaining screws| Take off the cover| Remove the gasket
Position the Prefilter inside the filter chamber| Place a felt gasket at the bottom of the filter chamber
Place the HI-C filter around the Hepa filter and Attach the HI-C filter with the elastic bands| Unfold the filter slider (Supplied with replacement filters or on request Part#6F 001)| Roll it into a spiral
Insert the tube into the filter chamber inside the Prefilter| Let the spiral open to fill the opening
Open the top of the spiral to make a
slight funnel| Insert the Carbon canister to the funnel and hold it straight|
Let the canister slide down the filter slider
Pull the filter slider up out of the cavity using both hands and let the
canister slide to the bottom of the cavity| Remove the filter slider and fold
it for further use| Slide in the Hepa filter
To close the filter chamber
Replace the gaske| Position the indentation in the cover
into the center of the HEPA filter| Replace the 4 screws and tighten| Turn the
Airpura back on casters
Technical specifications
Odor, airborne chemical control
18 lbs German carbon Filter carbon 13″H x 13.25″OD x 9″ID
Carbon bed
570 in2 x 2 in deep
Particle removal
40 sq ft true HEPA
(Measured 1 side only)
12 pleats per inch
Pleats warm rolled with separators
Airflow 635 cfm
More cfm than any other home unit available
Pre-filter
570 in 2x 1 in deep
Size
23 in x 15 in
Weight
45 lbs total
Voltage options
110 or 220 volts
Watts
120 on high / 40 on low
Sound level
30.2 db on low (at 6 feet) 63.0 db on high (635 cfm) at test conditions
Air purifiers models and filter configurations
Alternates | Prefilter | Particule | Carbon |
---|---|---|---|
Alternates | Cotton Prefilter TarBarrier Prefilter |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>