AirPura UV600 Air Purifier User Guide

June 12, 2024
Airpura

UV600 Air Purifier
User Guide

UV600
OPERATING & FILTER REPLACEMENT
DIRECTIONS

To open the filter chamber

| | |
---|---|---|---
Turn over the Airport| Remove the 4 retaining screws| Take off the cover| Remove the gasket
| | |
Position the Prefilter inside the filter chamber| Place a felt gasket at the bottom of the filter chamber| Unfold the filter slider (Supplied with replacement filters or on request Part#6F 001)| Roll it into a spiral
| | |
Insert the tube into the filter chamber inside  the Prefilter| Let the spiral open to fill the opening| Open the top of the spiral to make a slight funnel| Insert the Carbon canister into
the funnel and hold it  straight
| | |
Let the canister
slide down
thefilter slider| Pull the filter slider up out of the cavity using both hands and let the canister slide to the
bottom of the cavity| Remove the filter slider and fold it for further use| Slide in the Heap filter

To close the filter chamber

| | |
---|---|---|---
Replace the gasket| Position the indentation in the cover into the  center of the HEPA filter| Replace the 4 screws and tighten| Turn the Airport back on casters

TO BEGIN USING YOUR
AIRPURA

Inspect the exterior of your Airport to verify there is no damage from shipping.
If any damage is noted, please follow the instructions from the distributor returns policy.
Wipe the unit with a damp cloth to remove any dust from packaging
Plug the unit into a regular grounded 110 volt outlet
Turn on the unit to MAX and allow it to run for at least 30 minutes
Set the variable speed control to the level you wish
The most efficient way to use your Airport for regular air quality maintenance is to run it at a low speed 24 hours a day 7 days a week.
Always maintain a humidity level of 40% or less in your home to ensure the unit is operating at optimal levels. Overly humid conditions can have an adverse effect on the performance of the carbon. When using purifier with a dehumidifier, please keep dehumidifier at least 6 feet away.

FILTER MAINTENANCE AND REPLACEMENT

The Prefilter
Can be vacuumed from the exterior of the unit once a month or more often. Should be replaced at least after 12 months of use

To vacuum the Prefilter
Use the brush attachment on your vacuum cleaner
Vacuum slowly around the mesh surface of the filter chamber
IMPORTANT SAFETY NOTE
Please ensure air purifier is turned OFF when plugging into a power source.
Failure to do so may result in motor potentially stalling and/or burning.

Replacing the UV bulb

Open the filter chamber following the instructions
Pull the bulb upward out of the connector
Push the replacement bulb firmly into the connector
Close the filter chamber following instructions

Technical specifications

Tobacco smoke odor, and chemical control
18 lbs activated Carbon 13″H x 13.25″OD x 7.5″ID
Carbon bed
2″ deep
Particle removal
40 sq. ft true HEPA
(Measured 1 side only)
12 pleats per inch
Pleats warm rolled with separators
Air Flow 560 cfm
More cfm than any other home unit available
Housing
Powder coat steel
Size
23 in x 15 in
Weight
45 lbs total
Watts
120 on high / 40 on low
Sound Level
28.1 db. on low (at 6 feet)
62.3 db. on high (560 cfm)
(Room level 25.1 db.)

Air purifiers models and filter configurations

Alternates Prefilter Particle Carbon
Upgrade Cotton Prefilter
Turbaries Prefilter HEPA 14 Filter (99.99%

efficient @ 0.3 Microns)
HEPA 14 Filter (99.99% efficient @0.3 Microns) + TiO2| 26 lbs Impregnated Carbon Filter (35/65 % Blend  : KI/Potassium Iodide, Coconut Shell Carbon)

EPA Est. No.: 100723-CAN-1
5510 des Rossignols„ Laval, QC, Canada, H7L 5W6

Documents / Resources

| AirPura UV600 Air Purifier [pdf] User Guide
UV600 Air Purifier, UV600, Air Purifier, Purifier
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals