delight 55302 Motion Detector Alarm with PIN Code Protection User Manual
- June 4, 2024
- delight
Table of Contents
55302 Motion detector alarm with PIN code protection
User Manual
You can know your family and valuables are safe thanks to this wall-mounted, battery-powered alarm. The PIR sensor detects the movement in the room and gives a sound signal depending on the setting. Ideal for the entryway of shops, restaurants, office buildings, or for home use.
4 functions:
- Entry mark (Short beep when motion is detected)
- Instant loud alarm
- Delayed alarm for entering PIN code
- PANIC button
Features:
- Energy saving
- Battery operated
- Digital PIN protection
- Motion detection
- LED feedback
Technical parameters:
Siren volume: 100 dB
Motion Detection Distance: max. 5 m
Power Source: 3 x AA batteries (not included)
Protection: IP20
Color: White
Dimensions: 138 x 106 x 36 mm
Startup:
Before use, remove the battery case screw and cover then insert 3 AA
batteries. Watch for the correct polarity. After inserting the batteries,
replace the cover and screw.
Use the slide switch at the front of the unit to select one of the above
modes:
CHIME – Entry mark
INSTANT - instant alarm
DELAY - Delayed alarm (20 sec)
Pressing the “PANIC” button will trigger an instant, very loud alarm.
To arm, the alarm (to turn it on), enter “0000” and then press the ON / OFF
button. To deactivate the alarm, enter your code and press the ON / OFF
button.
You can change the PIN to a 1 to 12-character number string, so you can enter
practically any code. To make a change, first enter the old PIN code, in this
case, “0000” and then press CODE to hear a beep sound, enter the new PIN and
press CODE again. A beep tone acknowledges and accepts the PIN code. Then
you can activate and deactivate the alarm function with the new code.
If you forget the PIN code, remove the battery from the back of the device and
replace it. This will reset to reset the “0000” security code.
Important note! It is recommended that you check the status of the
batteries from time to time since the device does not indicate when the energy
level of the batteries is running low. Operating low-energy batteries can
create a false alarm! When the battery is changed, the PIN code will change to
“0000” so it will need to be re-set as needed in an above-mentioned way.
Do not use the alarm in humid, wet environments or with wet hands. When
placing the appliance, be sure to position the appliance in such a way that it
is not blocked and the sensor can sense any movement without difficulties!
Documents / Resources
|
delight 55302 Motion Detector Alarm with PIN Code
Protection
[pdf] User Manual
55302, Motion Detector Alarm with PIN Code Protection, Motion Detector Alarm,
55302, Detector Alarm
---|---